03-01-2005, 03:35 AM
|
#1 (permalink)
|
Offline
|
|
|
|
KDP, Timing Project
Howdy,
Since I am new to 2nd Gen's, you'll have to bear with me.
I am going to pull the front cover to tab the KDP and replace the front seal, front cover gasket, I am off of college all next week for spring break, so I will have plenty of time. I decided it would help alot to set the timing since it has 225,000 miles on it. I'll probably order the Snap-On timing set. Any advice would be appreciated.
Where can I get the delivery valve o-ring? Does it need to be replaced?
This truck will be mainly stock, with the exception of BHAF, exhaust, guages, and maybe a torque plate and some pump mods. How much should I advance the timing? I would like to advance it some, but do not want to take away any bottom end.
Steven
__________________
91 W250 CTD 3.54 Getrag SBC 13" Con Fe BHAF 5" Mitres Di-pricol EGT & boost 16cm Mag-Hytec Borgeson 233.1hp and 568.8 ft-lbs
2001 2500 5spd 4x4 QC LB 4.10's Rip's 4" RV275's EZ BHAF Di-pricol EGT/Boost/FP Raptor 100gph
Sis' 98 12v 4wd QC LB 5spd 3.54 PDR HX-35/12 285/75-16's Rips 4" BHAF
|
|
|
|