05-31-2005, 03:52 AM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
|
|
Gauge installation question
I am thoroughly confused on what engine port to hook my boost fitting to. It is currently hooked into a port just below the intake horn. Also, where do i install the trans gauge sender in my tranny pan?
I already screwed up on the pyro probe. I put it in the cast iron pipe between the back side of my turbo and the start of my exhaust pipe. How much is this going to screw up my EGT reading?
Any help would be appreciated. Pictures would be nice.
I've been gone over a week and was in a big rush to get my new parts installed. I should've taken the time to get in touch with my TDR buddies instead of going out on a limb. I'm ashamed of my poor judgement.
__________________
97 2500, 223,000 miles, 4:10 gears, #0 plate full forward, K&N inbox, 370s, 5" stacks, 191 dvs, 3k GSK, Afc spring kit, Holset Super 40 turbo, Autometer pyro, boost, trans gauges, BD TC and VB, chrome rocker panels and fender trim, KDP killed. The truck is dead but the Cummins in it lives on.
|
|
|
|