01-22-2007, 08:51 AM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
Join Date: Jun 2006
Location: Pittsburgh Pa
Posts: 182
|
|
Clutch Fork ?
I'm installing a NV4500 transmission in my truck. I'm almost back together. After getting the tranny in, I couldn't remember if I installed the clutch fork with the part numbers on the correct side. I remember looking at it and looking at the numbers and thinking it has to go in this way but then I got distracted by my brother in-law who was helping. I'm 99.9% sure it is in the correct way. I put the tranny in gear and had someone depress the clutch pedal and the output shaft on the tranny turned freely by hand so it is disengaging. My ? is will I know immediately upon start up if it is in wrong and does my test prove if it is installed correctly? Sorry for the long post. Thanks Pete
__________________
1997 2500 4wd Ext Cab Long Bed, NV4500, South Bend Clutch, 149,000 miles, BHAF, Silencer Ring Gone, #10 Plate, CAT Gone and KDP Killed!!!!
|
|
|
|
Linear Mode
