05-24-2002, 08:03 PM
|
#1 (permalink)
|
|
CHarris - Moderator; HotRodDiesels.com
Offline
|
|
|
|
KDP Question
I'm planning on getting mine done in the near future so here's my question.Instead of the KBP tab, why can't you just hit the edges of the timing case gently with a chisel and bend a little of the timing cover hole over the dowel pin?
This should keep the pin where it belongs.
Anyone have something against that?
Not knocking the tab or the CPFF jig, just a question.
__________________
Curtis Harris, 12 valve Engine and Drivetrain Moderator
2004 Ram 2500 SLT Sport. Smarty/TST Stack. Tranny built by Michael @ HotRodDiesels. No other Mods. Best time 13.42 @ 101
www.hotroddiesels.com
|
|
|
|