01-02-2003, 12:21 PM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
Join Date: Dec 2002
Location: Lincoln, NE
Posts: 144
|
|
Tip on replacing front crank seal if you have the cover off...
I did the KDP tab yesterday. I put the crank seal in too since I had the cover off. After a few attempts at getting the seal to go into the cover I amost had to give up. It is the tightest seal I have ever seen! I then put the seal in the freezer and the cover in the oven. 2 hrs. later it went in WAY easier. Hope this helps someone...
|
|
|
|
Linear Mode
