[KKunz]

I recently bought a jeep to start as a project and the previous owners went a little over board on the bondo so I want to cut out the bad section and weld in a replacement panel. I was hoping that some one could recommend a good Hi quality Pneumatic Punch & Flange tool that is USA made. I was going to get one from snap-on but the one they sell only punches hear is a link

AT185, Punch Tool, Dual, Air, 3/16" and 5/16"

Any help on this would be greatly appreciated… What kind of Punch & Flange tool do the top end body shops use? I know it’s probable more than what I need but if I’m going to buy one I would like to have it last forever and work when I need it
Attached is a picture of what I’m fixing
Thanks