05-04-2004, 11:51 PM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
Join Date: Jan 2004
Location: Warren, MI
Posts: 126
|
|
Engine Oil temp Gauge
Any of you 1st Gen'ers run an engine oil temp gauge? If you do where did you run the sending unit? Is there a place on the block, or do you weld a bung on the oil pan (I'm not cracy about that one  ), or something else?
I have an extra hole in an A-pillar double and I'm trying to figure out what to put in it!!!  (I think I left myself open on that one!!  )
__________________
91 W250 Reg Cab, 3" lift 33" BFGs on Eagle rims, Auto Meter Tach/Boost/Pyro Tran temp, PW Injectors, BHAF, 14 cm non-wg hsng, HD tranny rebuild, 4" exhaust, govenor bumped up to 3,000 RPM.
|
|
|
|
Linear Mode
