05-06-2004, 04:39 PM
|
#1 (permalink)
|
Offline
|
|
|
|
Govenor adjustment?
I have just purchased the 190 injectors from PDR, I have 16cm housing, 3.5" exhaust and K&N filter, Auto trans with DTT convertor and shift kit. My question is I want to change the govenor setting as when I accelerate hard the govenor cuts back before the truck shift especially from 3-4, I have replaced and adjusted TPS. Do I just adjust govenor set screw or install 3000 rpm spring? which is better? Thanks
__________________
01,3500 ETH/DEE 4X4,Edge EZ,Bosch 275hp inj,4 in. exhaust,Buckstop bumper,ATS high arc intake,triple Isspro on the "A" pillar,SBC Con OFE, BD exhaust brake,Fast Coolers, Air Dog,Ice Box intake,Mag Htek,Custom Flatbed, Filtakleen by-Pass filtration.
|
|
|
|