08-10-2004, 03:56 PM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
|
|
Aux gauge lighting / wiring to allow for dimming
Finally got my Isspro tach, boost, pyro and trans temp gauges. Did a search, and got too many hits to review them all for my specific question, so here goes:
I want to wire the gauges so they can be dimmed at night using the factory headlamp switch (like the factory dash lights). Can't recall where I picked this info up, but can I just splice into the orange wire in the factory tach plug (I think that's the correct one for the lights) and run all 4 gauges off of this single wire, or am I asking for trouble? I know little about wiring, so I don't want to do something dumb and melt something - but then again, it seems these gauges can't draw much either. Any better/safer ideas or is this pretty typical?
__________________
SOLD: '93 W250, auto, 3:54s, 94k miles, KDP tabbed, 4" exhaust+downpipe, tach, boost, pyro, & trans temp, PDRHX35/16, pump tweaked, Mag Hytec trans pan, dbl Ujoint Borgeson, BHAF
Current: Chev 3500 Dually Dmax/Allison 4x4 crew cab
|
|
|
|