12-13-2005, 03:41 AM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
|
|
HELP!!! 3200 spring problem
Hey guys hows it goin? i just signed up but have been reading on here for a long time. ok i have a problem i put the 3200 spring in and did the AFC lever grind in the pump and got it all back on but now as soon as i start up the rpm's go way up  without doin anything.....could it be that the full fuel screw is just in too far? so i wonderd if i turn the full fuel out some will it idle like it sould? or is it just the throttle shaft not set right?
it was fine before i did this and now its not. so i still have it tore apart  thanks for any help..... with PODs and full fuel screw all the way in i had so much smoke i could stop cars at lights  just how much will it smoke now?
__________________
MICHAEL
MAY THE LOAD BE HEAVY AND THE TURBO WHINE
'91 1/2 D250 over 350,000 miles, stock auto  ,pods,full power screw all the way in  , 3200 spring,AFC lever ground,stock HC1 turbo/21cm housing,36psi/1500*,ISSPRO Gauges,single 5" stack.
|
|
|
|