10-12-2008, 03:25 AM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
|
|
Brake pedal to the floor
This happened only once today for about 2 blocks. I press on the pedal and it goes to the floor and the dash mounted brake light comes on momentarily. After a few seconds of driving, the pedal gets hard and it never happened again. I changed the master cylinder about a month ago so I cautiously ruled that out. I changed the front pads BUT never resurfaced the slightly ground rotors. Could this incident be simply the pads seating? It's rock hard when I stop now and the there are no fluid leaks. Thanks for any thoughts or suggestions.
Aloha,
Matt
__________________
- Matt
1992 W250 auto, dually conversion, 2" Skyjacker front lift, ASA/AFE intake, H1C/60 -16, Bosch 190's, Bully Dog fuel pin, 366 spring, modified pump, timing advanced and a 4" turbo back exhaust. Suncoast valve body plumbing 3.54's w/LSD. Autometer gauges.
|
|
|
|