09-11-2002, 11:54 PM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
Join Date: Aug 2002
Location: San Luis Obispo, CA
Posts: 31
|
|
outer axle shaft bearing seat
Howdy!!
I'm in the process of changing the front wheel bearings on my truck, and while I was at it, I removed the axle shaft too. I found that the seat on the outside of the axle shaft was ridged and pitted, basically in pretty bad shape. The bearing is shot too and I plan on replacing it, but what can I do for the seat? Can it be turned down with a lathe and then used with an oversized bearing? Any suggestions would be greatly appreciated. Thanks!!
__________________
Casey
Sold - 1991.5 W250 5spd
Bought - 2006 2500 CTD QC LB 4x4 Laramie, 6-spd, Line-x, B&W Turnover Gooseneck, Nerfs, Isspro EGT, boost and fuel pressure on the A-pillar, MBRP Muffler, Lost my kitty, AFE stg II, Rokkteck Crank Sensor
|
|
|
|