02-16-2003, 10:19 PM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
Join Date: Dec 2002
Location: Orange. Calif.
Posts: 54
|
|
Oil Preluber Question
Been fighting an Oil drip for a while. Finally found that it is coming off the oil filter ring that the preluber attaches to engine. The oil then collects on top of the oil filter and then down the side of it. I did not install the preluber, so my question is the oil filter ring screwed onto the oil filter mount or is it bolted on or both? I need to tighten it up to eliminate the drip. Anyone who has installed a preluber know this answer? I don't know what brand it is, it was already on the truck when I got it. It runs off an oil pump that is attached to the inside fender.
Thanks for any help on this.
Doug
__________________
1993 W-250 Club Cab LE. Getrag 5spd. 109,000 miles. Rhino Liner. Rancho 9000s shocks. Skyjacker 1 inch front leaf springs 6 inch rear leaf springs. BFG T/A KO tires. Borgeson Steering shaft. ASA Modifieds Air Intake, AFE Airfilter. 16cm Housing. Auto Meter Pyro & Boost gauges. PDR HX35.
|
|
|
|