04-05-2007, 08:10 PM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
|
|
Removing Line-x?
Hey guys, I am getting some bodywork done on a company truck, they need to remove the box side and install a new panel. The problem is the truck box has a spray-in liner (Line-x or armagaurd ect.) and it needs to be removed to do the cutting and welding around the seams, I've been trying to remove it using a torch and a heat gun to heat it but it is very slow going and comes out in small chunks. I've searched the internet and a few other forums, ppl say that chemicals and solvents wont touch the stuff. They said brakekleen, brake fluid, paint remover are all useless. So I'll ask here for suggestions has anyone removed this stuff before?
Oh, i also tried a grinder with a wire wheel but the stuff is incredably tough and the grinder wouldnt work.
Thanks, Dallas
__________________
'04 Quad cab, fender flares, 20" Eagle wheels, BFG All Terrains, Banks Six Gun, SMARTY, NADP Full Billet 48RE, AEM Intake, AutoMeter Gauges, DSS, KORE Steering Damper.
'07 5.9 Quad cab, 6" Lift 37" Tires, 18" MKW Wheels, SmartyJR, TS ShiftMaster, Muffler Delete, AFE Intake, AutoMeter Gauges
|
|
|
|