04-13-2009, 06:04 PM
|
#1 (permalink)
|
Offline
|
|
Join Date: Jan 2002
Location: Lincoln, Maine
Posts: 1,955
|
|
Ball Joint Replacement Procedure w/pics
Here is the method I use to change my Ball Joints. Was a little nervous when I did the right side as I never done one with the ball joints pressed in the axle before so figured that a post of doing the left side might help someone else.
Picture 1 * Stripped down knuckle
Picture 2 * Loosen, but don't remove nuts. They will catch the knuckle when it drops.
Picture 3 * Pickle Fork. Use on upper, then lower, then upper. Should drop at that point.
Picture 4 * Knuckle dropped down.
Picture 5 * Knuckle off.
__________________
2006 2500 4x4 Mega Cab SLT Auto 3.73's
Inferno Red 118,000 Miles Jake Brake, Edge w/Attitude MagnaFlow Turbo Back Exhaust System
1997 2500 4x4 Reg Cab Laramie Auto 3.55's
226,000 miles and counting.
2002 Chrysler T&C
2008 Chrysler T&C
2004 Cougar 290RKS 5th Wheel (I know, I know)
Last edited by mwilson; 04-13-2009 at 07:00 PM..
|
|
|
|