04-17-2003, 08:55 PM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
Join Date: Oct 1999
Location: Eudora, KS. USA
Posts: 615
|
|
EGT gauge, Where to drill the manifold?
First of all, pay no attention to my signature, this truck was stolen Friday morning in Kansas City. Getting ready to order an 03 next week, if it isn't recovered. (2500 Laramie, HO/48RE) Been looking at a few, and can't see any obvious location to drill & tap for the EGT pyro. After I get that figured out, I'll have to look hard to find a place in the cab that makes sence, for the gauge. Any ideas? Have been using a Westech combo boost/EGT from Geno's, and would like to use that again if I could, but where to mount?
__________________
97, 2500, Auto, 3:54, 2WD, TST 230 HP kit (forward 1/16"), 215's & 3K GSK, Goerend Bros. 3-D TC, 3 Pos. Lock up switch, 300+ RWHP, K&N, Combo EGT & boost gauge, Eng. & Trans. oil temp gauges, "Line-X" liner, (& a nice set of "Truck-Nuts") 235,000 miles!
|
|
|
|