06-18-2004, 03:51 PM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
|
|
DiElectric Grease
Use DiElectric grease on/in wiring harness connectors. ESPECIALLY on/in connectors at the lower part of engine -- like the crankshaft position sensor and flywheel position sensor (lower front of engine).
I've always been a believer in doing this. Note that the factory harness has dielectric grease in the connectors.
The main point is to seal the connection from outside contaminants; most notably water but also dirt/dust.
It's my opinion that many of the spurious codes and random problems with aftermarket boxes are caused by contaminated or less then perfect wiring connections. Not only does the grease seal the plug; it enhances the connection surface.
__________________
Mark A. Kitchell -- Big MAK
2006 HO 6spd 3500 QC 4x4 SLT - Travel/Hauler Rig
Stock plus gauges
2003 HO 6spd 2500 QC 4x4 Laramie - Sled Puller
First Win
Lotsa Fuel, a big clutch, a whistle thingy, and other stuff
|
|
|
|