|
Several Codes - EZ problem?
Driving home today, the truck started running very rough, rattling like a 12V, and I had no power (like a 12V  ). CE light came on. I immediately dialed the TST back to stock, no change. I got to an exit ramp, temporarily shut down, and re-started (ECM reboot)... no good. I limped to the shoulder, and the engine died. I pulled the following codes:
P0606 - ECM communication error
P0193 - Fuel rail pressure sensor circuit high input
P0236 - Turbocharger boost sensor circuit range/performance
I cleared the codes, checked over all the connections, and fired back up (truck had been off for about 3 minutes at this point). It fired right off, and ran fine. I left the TST on stock, but from the codes, this looks more like an EZ issue. I run my EZ on level 4.
Anyone else ever have this happen?
-Tom
__________________
2003 3500 Laramie QC LB DRW 4x4 HO 48RE 3.73
PDR Twin Turbos, Autometer gauges (fuel, trans, pyro, boost, oil, water),
SRT10 pillar pod, dual steering pod, triple dash pod, FASS Fuel System, ATS Manifold, 4" exhaust,
Aeroturbine, ATS Stage V trans, Billet Flex Plate, TST PMCR w/ gauges, Edge EZ
|