04-05-2008, 04:05 PM
|
#1 (permalink)
|
Offline
|
|
Join Date: Feb 2000
Location: Morganton,NC,USA
Posts: 119
|
|
Engine check light, no codes
 Need help,
Just added fuel pressure gage thru the geno cap, pressure is 8psi at idle. As I was testing the gage I noticed the check light was on, looked for codes(3 on and last left at run), no codes.
The only thing I can think is that I bumped something or as I was looking for power on the switch I upset somebody. I did pull some fuses and the one marked diesel transmission was pulled when I restared the truck. I may have pulled others too, could this be the problem? The trucks runs normal and all the gages are normal and all of the fuses are back.
I did the search and I am not sure that helped, except don't take it to the dealer.
Should I just run it to see what gives? I have all my wiring fused so there should be no danger of a fire. The voltage did not come up to center of the gage and that was a concern, but I have not been watching it.
Any suggestions will be welcomed.
Dave Mc
__________________
2005 3500 White Laramie LB Quad Cab 4X4 6 Speed, Edge Juice, Brakesmart, air bags, overload spring bump stops, rear torgue bars, BD Exhaust Brake.
2003 Teton Sunrise Experience 33' 5th Wheel.
2006 Lance 1181 Camper, Been to Alaska.
2010 Can AM Spyder double towed in enclosed trailer
|
|
|
|