10-24-2009, 12:59 AM
|
#1 (permalink)
|
Offline
|
|
|
|
FASS 95 install
Well I bought a FASS 95 to upgrade my fuel system and finally got out to the shop to do the installation. Put the truck on the lift and started calculating what it would take to get it installed.
After rereading the FASS instructions several times I thought to myself that the mounting location seems vunerable being right in front of the rear wheel hanging kind of low where debris from the front wheel get thrown up. 
I'm just not happy with this arangement so I looked around and thought to myself that I could weld up a much better bracket and mount it inside the frame rails near the trans crossmember in front of the fuel tank.
Anyone care to comment on their experience or alternative mounting solutions?
__________________
2004.5 2500 Quad Cab Laramie 2WD, Jeff Garmon built tranny, ATS 5 Star Converter, Billet input shaft, Billet flex plate, ATS Commander=(TC lock-up controller), Autometers, FASS 95, Prodigy Brake controller, Bilstein shocks, Fold-A-Cover bed cover.
|
|
|
|