10-28-2009, 10:58 PM
|
#1 (permalink)
|
Offline
|
|
Join Date: Jul 2001
Location: Gull Lake, Saskatchewan
Posts: 719
|
|
Dynatrac hubs
I have a wheel bearing on its way out and was thinking of the free spin conversion as I need a new bearing.
I have heard that the bearings are ~$500 up here. so I would get two sets of bearings and the locking hubs for 4x as much. Money is tight but I heard that when you have a bearing failure is the time for the conversion.
I just had a buddy that wrecked the front half of his transfer case when a yoke broke on the front driveshaft. $1300 for the tcase and $250 for new u joints in a used driveshaft. Maybe its worth the extra $$$ in the long run.
__________________
'03 2500 QC LB 4x46sp CPL 8228 Smarty JR, FASS 150/95, Timbrens, airbox mod, Tranny Filter, Cool Hose, HE351 Centramatics, ATS ex manifold, 4" exhaust Cooler Tubz DT Free-Spin Fluidampr 150,000 mi 33psi 1250F SW3
'92 W350 w/ Hydra-Dec PTO hyd pump NV4500 HO injectors, 16cm housing, Borgeson Shaft
|
|
|
|