dse in truck 04-05 CTD - Page 40

cj hall · 11-01-2009, 08:28 PM

Hello to all
I got the new heaters is one of my totes

they are made from .500 ss 304 tube bent in to loops that attach to the top of the totes with pop rivets
each tote will have 4 units in them and they rest about 3 inches from the bottom of the tote

I will be running a solar panel for heat and also a heat exchanger from the barrel stove if the solar is to small.

I have pictures on my email and will try to post them soon

thanks for reading

cj hall · 11-01-2009, 08:35 PM

here they are

thanks for reading

ps.4 years sure goes fast

cj hall · 11-02-2009, 03:45 AM

hello to all

here is the new centrifuge I have been working on it all done and making great looking oil
These pictures are from my blackberry phone i must say it takes a nice picture.

here you go thanks for reading

cj hall · 11-02-2009, 03:48 AM

here are a few more

cj hall · 11-04-2009, 08:10 AM

hello to all

Tonight after work I started the make over of the 2001 dodge I got a year a go. it has a stock lift pump that is weak, will be burning vegetable oil in this one so needed to start by puting on a heated tank and a fass unit,

the tank is a stock one with a heating loop (arctic fox) this was installed and a new dip tube was installed the tank was from a wrecked 2001 so it only needed to be cleaned and all the parts put on it. this was done around a month ago.
The fass unit is a 150/95 big filter unit, the only thing about the fass unit I dont like is the mounting brackets they send, so this time I took my time and made my own using nothing they sent. I wanted it to be rubber mounted and to the frame and up as high as it could be with room to hook up all the hoses to and from the engine and fuel tank. not asking for much here.

the install went great and the holes in the frame worked great for mounting the bracket. the parts I made are power coated bright red the pump housing is red also no other holes needed in the frame dodge put them there

here are a few pictures of the brackets and the punp installed on the truck

thanks for reading

I will post more pictures in the next few days.
hope to finnish the install this weekend if not sooner.

cj hall

moparguy · 11-04-2009, 12:38 PM

CJ, great workmanship. I always enjoy reading your updates. My work keeps me from doing anything except pulling up to the pump, but someday I'll be home with time to benefit from your efforts.

Keep it up.

RR

cj hall · 11-04-2009, 07:33 PM

Hello to all

Thanks moparguy,with the cost of fuel going up its hard to decide what to do buy fuel or food some day I hope we are all burning vegetable oil but thats a long shot. just a few people at this time doing it.

here are a few more pictures enjoy.

thanks again

cj hall · 11-16-2009, 04:25 AM

hello to all

will its been about 10 days and the truck is running great running with only this blend in the tank,we have put on over 600 miles so far.

the fass pump is not loud in fact you can not even here it run the mount worked out great, the next step is either a smarty or edge for the performance side of my vegoil sickness.

I want the gauges of the edge but I really like the smarty just not sure what to do .

Thanks for reading

cj hall