- Fluidampr on an Auto-Equipped Truck
- Good Service From Isspro
- getting there
- Cummins air filter part #
- 7.55mm lift spec...
- T/C Lock-Unlock
- stripping injector lines
- 100 Fuel Plate. What Gives?
- Heater core leak.
- part number please...
- Charging Problem
- how much power
- Injector installation information
- Injection Pumps off ebay
- FUEL PLATE #ing system
- 95 died warming up won't start
- Need info on the fuel Pre filter
- 330 Injectors
- Which fuel plate
- going to put it all back together soon
- Stupid starting procedure question
- Over Boost
- new-to-me truck. ???'s
- Oil air filter question
- This is why you don't put off KDP fix!
- 160 Pump Stumble
- Jacobs exhaust brake, Low power.
- empty fuel filter
- stock 215hp Injectors
- trans slipping?
- Throttle return springs on '96 manual.....
- Battery question
- Need Brake Claiper Info
- New clutch, shift hard?
- 0 plate picture
- rear end
- Help-Very Hard Starting 96
- Governor arm adjustment
- Pressure plates
- What plate is this?
- Anybody got a picture/blueprint of a KDP jig
- Problem with a stock '96 that's been sitting...
- Timing Question
- hanger bearing
- 8.3 lift pump on a 1998 6bt 12v?
- 2 wheel low HELP
- suggestions,advise
- 330's in a 160 pump?
- 98' QC 12v auto on ebay
- what's a nv4500 worth
- Tappet Cover leaking
- Standard Transmission Overfill ? ?
- please help id my convertor "17g"
- Transmission check valve
- Thanks Larry B's!!
- tranny line fitting?
- wasted high revs through acceleration; auto trans help!
- Would I gain...
- Damn Transmission!!!
- Easy question re crankcase breather
- no idle
- Governor lever adjustment
- Grid Heater question
- Egt's And Exhaust Size
- Difference Between 94 Dually 80 & 01 Dually D80
- couple questions on my dad's 12 valve...
- A/C on off
- Sweet Spot?
- Axle flange bolts working their way loose!
- Building my twins
- Fuel gauge fix
- can't figure this one , help me out guys
- why more power at 1/2 throttle?
- Killed KDP
- ABS/ air bag lights on, no power windows
- Gears
- FASS installed on 12 Valve
- Fuel Leak and Replacing Fuel Lines.....
- NV5600 question
- Tranny noises, strange!
- 4th gear grinds
- Engine is out, what should i do?
- newbie and i need more power!
- Changing out my transmission
- Oversize Tires
- Got the Last Laugh
- 13" flywheel?
- Holset compressor wheels
- 18 deg too much?
- help installded 4 GSK bad running
- Blowing Fuel Pump
- nv4500 apart, what to do?
- Considering auto to manuel
- Odd noise on startup
- HX35/Super 40 Hybrid Turbo
- Transmission-How far can I go ?
- Over Heating Problem
- head issues
- intercooler repairs?
- Fuel Solenoid Relay location
- "Fuel Additive"
- Is this axle spindle usable? (damage from spun bearing race)
- 1994-1998 P7100 differences
- Idle Speed Adjustment??
- Starter dragging
- Flex plate PT#
- Pump being rebuilt..specs. to calabrate
- Delivery Valve Oring size
- front cover leak
- Crankcase pressure (Oil Leak UPDATE)
- Too much blow by???
- Boost ?
- lol, newbie mistake on lever arm adjustment
- Fuel Leak FIXED and a Fuel Heater Question
- low boost, hissing sound
- Button,shim,something on the front of the P7100
- Missfire
- Just a question.
- Need Intercooler
- Oil Leak
- where else to buy?
- Drive line dead spot.
- 4X4 not working
- Need answers to my boost problem.
- no tach, speedo
- Boost Question
- Another one on pump timing
- No Start
- Need Help
- Minnesota Cummins owners
- Fuel plate
- Do I need a 1-3/8 input shaft?
- clutch sensor?
- KDP near miss
- Looking at 98 12 valve, have questions.
- Fifth gear fixes
- Fuel heater/prefilter gasket for a 1995
- fuel guage sending unit
- Soot on turbo intake
- crankcase pressure problem
- Leaky injection pump on my '93 D350
- New Diesel Fuel Stds vs 1997 CTD
- Questions about Stack install
- Belt tesioner pulley, a/c vs. non a/c
- Isspro gauge question
- Size of AFC screws
- NV4500 is a quart low...is there damage?
- Driveshaft yoke
- water in diesel best additive to use
- Upgrade Questions
- Starter Brush Replacement Question
- Looking for info on TAD B-1
- Fuel Drain Back
- Front seal question
- Engine sitting for 2 years-now what?
- new owner 97 12v 168k some mods need advice
- Starting Problem
- Idle Adjustment Screw
- automatic to manual 4500 conversion. possible/affordable?
- Fuel filter drain
- Injector opinions
- Truck Questions
- Diagnose This Noise :-)
- new tranny leaking pan getting frustrated
- Help ? About Starter
- Oil filter only half full at oil change
- 1995 Ctd
- Is a NV5600 conversion worth it??
- Intercooler Boot Leak
- Dually Dana 80 Brake Backing Plate Parts Question
- The Oil Pan
- (help again)metal in screen in preheater
- Redline questions
- morning sickness
- Think my timing slipped
- help need a mechanic
- Running hotter w/ smaller inj's
- Turbo Pinwheel Size
- Best oil in the nv4500?
- KDP...almost
- Low Fuel Pressure
- Fuel return line
- Looking for an ole 12valve
- 12V Lower Radiator Hose
- Throttle Position Sensor Assembly stuck
- New cheap lift pumps on ebay, part number question
- Timing needed in PA
- Rebuild or New Engline?
- TQ converter bolts
- KDP jig drawings available?
- Fifth gear diagnosis
- '95 2500 won't start
- Prescription for power???
- 370s with my setup now..
- 2004 4x4 4 door 1 ton dually
- Boost Levels
- Loss of coolent after changing headgasket
- 12v shutter
- AFC settings
- any KDP jig keepers still out there?
- How much smoke is too much?
- Air conditioning help
- Torque Converter Install
- Greg Hogue's cam
- VE, P, VP44, or CR
- blow down tube
- 95 Broke down fuel leak
- fuel pressure gauge ?
- ATS exhaust manifold
- Goerend tranny and power?
- Found my studdering problem!!
- stuck universal joint
- I need a tranny temp gauge for my 95
- fuel pressure readings
- Help with 96 cummins fuel pump
- Holy Smoke
- Loss of boost after head gasket replacement
- Fuel Plate/Afc Cover again
- Fuel lines location
- Auroura 2000 turbo/HTB or Hybrid
- What is the 12 Valver's Average Service Life (mileage) ??
- How many miles does your STOCK 12 Valve have on it ??
- How many miles does your STOCK 12 Valve have on it ??
- Fuel Primer Button...
- # 8 plate full forward?
- Potential Mod ?'s
- will fuel plate wear pump?
- Luke's Link
- 300 VS 370 injectors
- low silicate coolant
- Likely sources for trace fuel in oil?
- where do I get the improved starter contacts?
- torque converter drain plug
- High Idle Solenoid????
- Timing??
- ? about Sliding AFC
- Fuel Timing
- Fuel shutdown relays
- After market fuel pump plate.
- HELP!!!! Didnt pass emmisions
- turbo works doesn't work question
- Speedometer working not!!!
- Rear End Swap
- help with oil coolant problem
- Leaky delivery valves, INTERESTING FACT!
- engine sweet spot
- What is this & do i need to keep it? Coolant Reservoir?
- Egr Valve Repair
- brakes
- What size exhaust housing should I get?