- Insulation
- Funny sight.
- Water pump failures?
- fuel screen problem
- HX40 Boost Pressure
- Injector Pop off Pressure
- Abs Lights
- Return line replacement hose
- finding cam plate original position
- 5" chrome stack is on....
- Thanks Cpff!!!
- Low RPM @ Idle
- Lift Pump ???
- Won't Shift!
- KDP Fixed today
- Anybody in Portland have a tire?
- Carrier Bearing
- First time Dyno Results
- Silencer ring?
- Best Fluid for my buck????
- hard starting i think it's fixed
- Dana 60 axle seals leaking
- WARNED: Not to take Dana 80 apart
- I Did It!
- KDP ... Almost Got me!!!!!!
- Trans temp pegged!
- idle speed dropped
- Lost Spiders, Dana 80, need pointers
- grabing a lower gear
- hx40 turbo
- pump timers... whats the secret??
- Covering Oil Pan
- Fuel Solonoid Failure
- Clutch time, con-ofe questions
- 12 hour tranny swap
- KDP inspection
- brake switch question.....
- Where do you buy your stuff???
- looking for my 1st upgrade
- What happened??
- Need turbo silencer
- Leaking front seal...crank shaft
- Not Good!!!!!!
- KDP Question
- Something different happened today?
- Stumble w/ Gov Lever too far up?
- Governor Spring Install w/ Pics at Fritz's Web page
- Dyno’d 360 HP, want to break 400. Your suggestions?
- Help with 1997 3500 problems
- 12v auto turbo on 5 spd engine?
- dowl pin party in Sacramento?
- Need HX-35
- The 3K GSK is in!
- Axle grease seal spews.
- Fuel line shopping list?
- Cummins Survey
- Will it Hold?
- Fuel leak
- Auto overfilled? dipstick length?
- GSK Not for towing??
- autos and KDP?
- what do you think of the new forums?
- picked up my first cab and doors
- KDP & The *******
- buying a new truck, what to watch for in a 5spd?
- DTT
- ATS tranny wont shoft into OD
- AFC Housing Question
- Question on #8 plate setting.
- Cummins number on your pump?
- Boost problem with GSK....Solved!
- 5th Gear Replacement, A good report you should read!
- Dtt Rocks!
- Rear Axle Seal Problem!!!
- Starter does not disengage
- Clutch info ???
- Why is this?
- Boost ?
- Automatic Transmission Problems
- Got my E-mail from Cummins!!
- Hardest "No" decision I had to say to a 12v purchase
- P7100 question
- Which power steering pump?
- filling fuel filter when changing--- an idea!!!
- Has anyone actually used the 6"-# wrench to adjust valves?
- TC Locks Up at 45 MPH
- Boost problem with GSK?
- Checking Head Torque good idea ??
- '94 Ram 3500 power suggestions please
- No Oil Pressure!
- Transmission Lag
- Solved! Low rpm and sudden stall
- timing
- trans cooler line
- My timing experiance
- Who has switched 2500 rear wheel cyliders for 3500 units?
- Hints to setting the valves..
- Need help tuning AFC to #11 plate
- drain plug in tranny pan
- Top speed
- #11 finally in
- turbo housing
- 24v head on a 12v?
- Oil In Coolant SAGA Continues
- Drill jig for KDP
- P7100 Problem?
- Lift Pump Replaced on Stock '97 3500
- water light on is there a drain on 97
- No O.D. or TC Lock
- TST vs. mileage
- Truck didn't start!
- HELP...setting valves..
- Got a little problem
- 2 & 1/2 days driven on re-installed silencer ring
- HELP! Oil In Coolant
- A/C quits after 55 mph
- oil leak
- trans fluid level on my stick???
- Why do i have a fault code 22 without a california truck?
- The exhaust elbow is smaller than the turbo outlet!!!!
- HELP? Growling/Vibration starts at 1750 RPM
- performance
- Overflow Valve
- egt's
- Go'in to flip my stock plate around to make a 0 plate
- TC Question
- Peeling paint?
- put #6 plate in
- Rear seal leak?
- Can You Recommend An Exhaust?
- Torque Converter on auto seems to unlock
- Exhaust leak
- JIG in modesto, ca
- Wich DVs do I have?
- Sold my truck last night, now what?
- 215 Cam Plate
- Starter Hesitation
- is my injection pump correct?
- cheapest source for a p-7100?
- intercooler
- Trany Sliping away
- What is it?
- excessive smoke??
- Installed an air blead and pressure port on my P7100
- belt replacement
- NOS, twins and custom camplate are in!
- To anyone who has purchased a 13" upgrade from us
- Re-installing silencer ring (Opinions wanted)
- brake problem
- can't find the location of the overflow valve in my service manual
- Throttle rod adjustment
- How do I adjust idle
- Sachs Clutch built by Joe Donnely
- track bar
- dipstick spitting oil
- checking fuel pressure
- Low Idle and sudden stall
- 14cm wastegated exhaust housing
- bosch 370 injectors
- camplate?
- Throttle Position Rod
- Delivery valve washer
- Transmission carnage in Muncie
- AFC housing
- Idle at start up?
- Ajusting valves
- Timing pin
- Transmission problem question
- Can anyone locate by digital photo....
- KDP fixed-ontario,canada thanxs CPFF
- Injecters and DV info.....
- GSK installation help
- Best way to blead air out of the P7100?
- 180 and 215 pump barrel question
- Valve cover gaskets
- Crunchy rear end!
- Rear Differential lube ??
- McLeod Clutch
- P7100's, turbo's and Injectors!
- What is that hose? (and other stuff)
- engine running hotter than usual
- post brake job wierdness
- syn. fluids
- Barrel rotation question
- A Dynoed 1300rwhp 12v 5.9....
- 97 Exhaust brake questions
- Rebuild transfer case while tranny out?
- Rebuild transfer case while tranny out?
- rear axle lubricant
- KDP cracked gearcase?
- P7100 No Idle.....What's Up?
- AFC star wheel
- n ew recall
- low rpm quiver
- Bell Housing Inspection Cover?
- Why not drill hole in cover, for KDP fix
- help needed bad.
- With a NV4500 when you lost 5th gear - what happened?
- Alternator pulley
- Need Part Number for 60lb Valve Springs
- Doing my 3000 GSK this weekend
- TST #6 and 215`s
- Help! I've got a rattling sound in 5th gear.
- AFC diapham??
- Valve spring install questions
- Funky vibration in my rear end.
- cpl tag
- 370s Installed. Hope I got it right.
- Funny sounds
- TPS question?
- Ok - KDP
- 215’s Verses 230 Injectors?
- Muncie carnage
- alternator output voltage
- catalytic converter
- 405 HP Checked With G/Tech
- Help ball joint advice
- Waste Gate not working
- Oil Sample Results
- Primelok Fuel filter relocators on Sale?
- Factory gov springs
- gov press sensor = trans temp sensor?
- I called Piers, he's not sure.
- Two problems!
- Transfer case buzz/49 state what?
- cpl tag
- need a pcm wiring harness for 98 12v
- Adding a capacitor to the alternator....
- p-pump and injector conclusion
- Where's my boost?
- KDP.......Thanks
- Transfer case seal part #'s
- Which turbo for towing??
- 5-speed to 6-speed swap in a '97 4x4: can it be done?
- Stupid Stupid!!!!
- t--boned by a tempo
- A #4 Plate...Should I, or Shouldn't I
- Front Springs
- Hard start after it's been running ?
- Need exhaust advice please
- Fan Clutch
- It wasn't cool when I lost my horniness
- Wouldn't shut down
- Goerend vs the others
- 370 injectors?
- A/C don't work
- On a 96 truck - does it use PAG or Ester oil in the A/C system?
- Engine from medium duty?
- Throttle cable stuck story on CNN
- Any tips for switching trasmissions?