- KDP got another one/bad
- Which Turbo ?????
- truck died?
- Ted Janitty
- adjusting the TV cable?
- transbutty, do I need one?
- bombing rear brakes
- Piers spring kit!
- Death Wobble Revisited....
- Upper & Lower Control Arms?
- altitude & plate
- Timing the ole' 12v'r
- DD2's
- Location of all abs sensors
- Ticking and rough start this morning
- What size?
- I know another mystery switch question!
- What Size Door Speakers?
- measuring fuel pressure
- lesson learned
- It wasn't a bobcat or a briar patch
- How Long Should it Take??
- where to put fuel gage
- Is this right?
- 370's,3000GSK IS IT LEGAL?
- Hard starting when cold
- KDP contained. Thanks Rammin On!
- At what HP do head gaskets blow?
- looking for overflow valve repair kit part #
- Double the Pleasure, Double the Fun
- I found a deal and gave in..........
- Good info.
- Toggle for Cargo Light?
- KDP: Good News & Bad News
- Towing in O/D?
- embarassing moments for $100 Alex
- KDB Jig location
- Something binding, holding truck in place after startup?
- 2wd to 4wd conversion
- Grinding noise when turning
- Failure to start
- Unable to turn injection pump gear CC with gear puller.......
- Fuel Cost
- Knuckle with lot of Play.
- Larger Exhaust Tip - looks or function?
- The "Infamous" ABS/Brake light problem
- Dana 80 or hybrid? what's the difference
- Ah, the joys of performance
- oil burning smell after oil change
- 215 injectors and #6 plate
- the color of gear lube in front axle of a4X4
- 15.5 deg? 16deg? or....?
- mileage 12v
- trans temp sender location
- clutch install help
- PACBrake is installed
- What about a smooth fuel plate???
- faulty oil pressure gauge?
- Engine Surging, any ideas?
- Front End vibration 2001 2500diesel
- 2nd Gear Starts
- New member
- What temp for factory trans light?
- Governor Spring shims
- help with setting inj pump timing
- Solenoid Boots and hardware available.
- Holset HX40W turbocharger
- WIF Replacement!
- Exhaust System
- KDP Jig Southeast
- #11 plate slid all the way forward
- boost numbers for my truck
- Over Heating?
- More Mods...
- You ain't going to beleive this.
- 5th gear noise
- $200 for a Dyno run?
- What Next?
- Turbo barking?
- BD Pressureloc?
- HAPPY with new PDRHX40w
- KDP contained
- warped hub and rotor
- Lots of hammering ...lift pump??
- 3k gov springs
- Timing & KDP-Same Cover?
- Picture of a #11 TST plate wanted
- BHAF Part #
- Starter Problems
- Stick replacing Auto?
- Dyno Testing H.P vs. Torque
- 1995 Injectors #7320 ?
- sliding rear windows, $60
- Problem: Accelerator pedal resistance
- Vacuum Plug on top of transfer case?
- shendren
- Strange brake problem
- Rear axle to hub bolts
- Cubic Inch vs. Boost ?
- I went to start it and....................!!!
- Bosch Torque Plate?
- bully dog torque plates & injectors
- fuel shutdown solenoid, can it be rebuilt?
- Crack in exhaust manifold?
- To Install 3k Gov Springs
- About fuel lines Question.
- Starter Stopped.
- Loss of Breaks when backing...
- Thermocouple placement??
- the 50/50 question
- Mag-Hytec trans pan bolts??
- 275-300 hp injectors for 96
- Power of TST#4
- timming and blue smoke?
- Hand Gernade Cummins
- Where do you tap in for the Boost Guage ??
- Uh oh, I've got a lil problem... Coolant Leak when plugged in
- 4K gov spring help!
- Found the CTD power cure,this one ain`t no turkey no more
- help needed in the San Jose area
- help with fuel shut off...
- 12 Valvers Only.Repeat.12 valvers Only!
- Star wheel vs. AFC housing
- Is your DTT an 89%, 91%, or 93%? POLL
- My KDP is dead..
- Pencil magnets are made for....
- Auto transmisson VS 5spd
- rubber fuel line
- Help needed - Compression test (a bit long)
- Truck is going to the shop today
- Injector puller?
- How much do you like the 370s?
- no front axle disconnect?
- Matco Timing Kit?
- truck rarin to go
- How to determine 12V by Vin # in 1998 models
- Self Starting Diesel -- Just passing www stuff along
- Got Money, Ready To Bomb
- 95 trans/coolant bottle
- Oil fill tube part number
- Moanin and groanin
- Drone is gone
- Losing the ring
- nv4500 problem
- 12V Injector Question
- 3kgovspring?
- KDP jig
- Help,what is the best build for this engine vs cost to get 300hp
- KDP - on my own i guess
- Tranny noise nv4500!
- I jumped ship on the 24V guys...
- Big turbo on ebay!
- KDP Washer Tabs
- Dirty NV4500 oil???
- do i need a egt guage?
- 4 inch pipe
- Closest TDR-Sponsor?
- What should the guages read?
- Freightliner or Mack Pyrometers...
- Fla Kdp Tab Fix
- Amsoil Air Filters
- trans temp. first time poster.
- Killed a KDP today
- AFC Shimming for greater rack travel
- Brake time.
- Cummins Part Numbers - KDP Tab
- valve cover torque
- Exhaust Brake Problem
- KDP in service manual?
- Exhaust System Help Needed
- gauges?
- +.20 headgasket and hard starts
- Coolant question
- Attempted to do the KDP fix today - All right you KDP gurus - explain this one!...
- Fuel Plate Foward?
- Fuel pressure gauge sender install location..
- Need some plate ideas!
- Fuel Spinners?
- KDP Finish
- 5 speed hard to......
- At what mileage did your waterpump go out on your truck
- 4 wheel steering
- 250 fuel plate & 160 injectors?
- What causes shuddering in the tranny
- KDP, why not use a roll pin?
- My HX-40 experiences!
- Can I buy a KDP jig ???
- Pros & cons of kevlar or brass for clutch application
- KDP jig bolt
- Truck is sticking?
- Auto fuel pump = polishing a turd?
- Throttle cable
- 4000 rpm springs
- Different injectors? 180?215,and 370`s
- Thermocouples
- Brake line boo-boo on 95's
- changed my prefilter today.....
- Shock recommendation for 5”lift
- Exaust Brake
- Governor lever adjuster question
- exhaust
- How do you talk to these guys that don't read the TDR.
- BD #8 plate same as a TST plate?
- Question on 89 and 91% TC
- 4.10 axle
- Valve Covers Leaking
- Waste Gate "Woosh" noise...
- fluid leak
- Start-up selanoid relay
- abs system
- Can't find the "pill bottle"
- RPM question (2 part question)
- Stacks are on WOOHOO
- ABS question
- Power Upgrades
- exact differences between 160, 180, and 215 pumps?
- Trans getting tired
- Fan Clutch Removal
- Delivery valves
- Flywheel resurface 101.....
- Recognize this plate?
- Scotty air - grudging acceptance
- 215 Injectors
- Torque Converter going?
- 230 injectors?
- Piers' rocker adjustment is worth the trouble
- Turbo shaft play?
- Tranny shudder going in to OD
- SunCoast Converters
- New member with Cummins knowledge but need advise on purchace of use truck.
- Pressure Bleed valve instead of Wastegate?
- Cylinder Head Torque
- cummins shop
- another abs brake light
- Brake/ABS idiot light
- Lost fifth gear today Oh, No cant find archives
- TST 16 cm turbin housing help
- noise on start up
- stumble & mysterious low power with 370
- Kdp Strikes Again!!!
- care to share?
- TST # 4 plate
- Leak
- Scotty intake in - not pleased yet
- Walker Muffler Part #?
- When doing the KDP fix, How to keep the engine from turning when installing balancer?
- What do I have here
- MPG and a bad overflow valve
- Straight-piped - thanks everyone!
- Insulating intake?