- Fuel Sending Unit
- Diesel Prices
- Engine damage
- Straight pipe or Muffler?
- Tremendous Loss of Power
- Jacobs Exhaust Brake Question
- Jacobs exhaust brake for a 97.
- Diesel Injection
- SBC Group Purchase
- How to read a torque plate chart
- Poor Performance & White-Gray Smoke
- Transmission
- Ticking Noise
- Fred Swanson--Desert Diesel parts
- How many miles on stock clutch?
- Slow crank when cold
- Hydo Boost?
- Nv 4500
- High speed rattletrap - feels like truck is coming apart...
- Larry B's stuff in Dallas, Tx or Little Rock, Ark?
- 96 12 valve IAT information
- High Chromium
- Slip Yoke
- What is needed for a good pullin 350-400hp
- Wierd problem
- SHOW your RIDE!
- 1997 Cruise Control Issue
- how much has ULSD affected your mileage??
- Mystery switch / tc lock up switch problems
- Fuel Heater Removal ?
- 98' Cq Lb 4x4
- My Engine is Coming Out!
- Choices
- Finding Boost Leak
- Did I lose fifth gear?
- 53 block?
- Part Number
- In Pursuit Of More Power!
- Need directions for BOMBing Motor
- 3k Govener Springs
- Dv's
- Building from the block up.
- Is anyone running one of these?
- Do you recognize this truck??? About to buy need info...
- Questions about lift pumps etc.
- Voltage wont recharge after startup
- Good shops
- Timing..
- Eye burning exhaust
- Governor lever adjustment screw
- 4 inch downpipe question
- cummins conversion into 97 v10 questions.
- Badly Worn Throttle Linkage, culprit of odd shifts?
- Transfer Case problem ?
- Low Boost
- Valve Ajustment
- Water Temp Gauge
- 12v Headgasket Break In
- Timing with a timing light
- CPS test?
- Rough start at half tank fuel
- Stupid oil pressure gauge
- Keeping an HX-35 alive
- Is a primelok worth the money?
- Fuel heater...
- Cummins Serial Number
- coolant by-pass kit?
- Are all 12 valve rocker stands the same?
- Tranny slipping out of O.D
- Charge air cooler upgrades
- 12v Injectors
- 60 Lbs. Valve Springs
- hot throttle
- 94 2500 cummins no speedometer
- Marine Pistons?
- Fuel pressures
- 12v Head Gasket Bolts
- Twin Turbo's on 12valve's
- Fuel pressure gauges
- 97 problems
- gauge mounts for '98
- KDP Notes
- 12ver
- no fuel
- Poor mileage - worn injectors?
- Pump timing pin ?-changing timing
- 12 valve fuel heater problem and questins
- b20
- Rotella T in gas engines?
- Where to buy 181 dv's
- fuel shutoff sylenoid
- Fuel pressure gauge?
- cheap muffler for3.5in pipe
- What to use to clean injector hole seats?
- radaitor time,want a good one
- Wrong fuel in 98 12V
- 1998 Transfer Case -- broken?
- cruise control.
- 12 valve won't start after eng. cleaning
- Hard Starting
- 24v Breather
- 94 cummins transfer case question
- Will upping timing increase combustion noise?
- Machine Shop Needed
- Popped a tappet cover gasket
- Bubbles in engine oil
- No 5th Gear
- I can' breathe
- Htt Hybrid Upgrades
- Leaking fuel while priming
- 94 2nd gen idle questions
- No overdrive
- 94 12v questions
- 160HP engine vs. 215HP internal differences?
- Turbo impellershaft play
- Turbo shaft play
- Need Instructions To Remove Stock & Install New SBC Clutch
- New 12 Valve
- Why did cummins switch from the VE to P7100
- 4wd engage on axle
- Change out of torque converter question
- MPG's. It this about right?
- Injection Pump Timing Tools LOANER
- TransGo 47RH shift kit
- Crankcase vent hose size???
- Wrong Place.
- Guages,tach,check eng, alt. erratic
- bigger fuel lines for 12valve.?
- Block heater thermostat?
- P7100 internal advance?
- Marine Pistons
- K&n Replacement
- Cometic Gasket or not?
- What DV's to use on 160HP pump w/ 215 injectors?
- Cold Smoke Question?
- To change or not to change, transmission fluid?
- 96-automatic overdrive problem
- fuel filter relocation questions
- Best HX35
- 241 dld and 241 dhd
- Real expected fuel economy?
- Clutch Balance question
- Stall speed question
- Fuel shutoff solenoid problems
- 47RH Transmission shift sequence.
- Injector lines
- Havin' a hell of a time...
- fuel commponet locations
- Silencer ring
- Cummins uprate kit
- Which Cam?
- Alternator wire color
- Turbo Question
- AFC Starwheel Questions
- Upgrades for next summer trip
- Slight engine surge
- Hx35 Turbo Parts
- Bomb Party - Tx...
- KDP tab importance!
- Paint chips under rocker covers?
- Starter and trans questions
- rebuilding a 12 valve
- Ford V10 Swap For 12 Valve
- 3 Part Question
- coolant noise?
- Gauges
- Transmisson not going into 1st gear when I down shift!
- Pressure in the radiator!!!!!
- Cylinder 1 ex valve adj?
- steering box leakage
- Blowby smell in cab?
- anyone use soltron?
- Installing 215HP injectors in 160HP now?
- Quick Tuning Question...
- Manifold "stretching"
- 95' Transmission Line Questions
- Upping timing just a little.
- Whining OD in 47RE
- 3K governor springs with an #11?
- truck starts better with foot on throttle
- Oil Pressure Guage
- valve body & tv cable ? pressures
- Oil pressure regulator
- DDP's DV's
- Where to find shifter and other places for t case input shaft
- Any thoughts
- Smoke Screw?
- Need to wake up the 160HP pump?
- A question I've always wanted to ask
- 1995 Tranny Question / Problem
- Swap Questions
- 47RE transmission fluid leak
- Blocking the Injector return line
- I want to trade my 4:10 gears for 3:54's
- 94 wont start, need help
- tranny problems?
- 1995 CTD Speedo off, causing weird shifts?
- Quick Help!! 95' Starts and then stalls.
- Starting issue
- Installing ARP head studs
- Transmission
- timing help????
- Cummins 5.9 Engine Repair
- sputtering while motor is cold??
- Exhaust brake for 12valve
- Want to install exhaust brake on '98 12v
- dually fuel tank size
- Ultimate MPG 12V.....
- 5.9 and 8.3 pump differences?
- Tabbing KDP question
- belt tentioner? Someone have a pic?
- Manual shut off cable
- I replaced my 568k mile injectors today. Questions
- Throttle cable to linkage connection
- Heat exchanger ?s
- pic of #11 fuel plate?
- long time to get heat to cab, what gives?
- Loss of power, Hard pedal
- Billet bling for the 12v
- Which TST power kit?
- twin setup?
- Transmission Temp Sender Install question
- Won't start engine was sitting for 4 months..
- Starter help. Will a (early year, 99) 24V starter work with a (96) 12v Truck?
- What to do with PTO??
- Missing Cam Bearings
- 215 Factory Injector Options
- 12 v quad cab leaking oil at timing cover
- NV4500 noise at low speed and rpm
- 98 12 valve ?
- Rusted brake line
- Doa Kdp 9/30/07, 300.38 Rwhp 11/10/07
- Motor mounts for 1996
- Turbo Suicide
- No power and white smoke at high rpms.
- Mystery horsepower
- sudden automatic failure
- sudden automatic failure
- Looking for a stock fuel plate
- Is this a good port for oil sampling?
- building an engine any suggestions?
- v10 swap.
- so lets talk 12v
- torque plates
- Found parts inside my oilpan!!
- Do I need new parts?
- How to get the most power from a 160HP engine?
- Changed fuel filter...no start
- Got my 95 Dodge back from Cummins tonight
- Slow '94 Auto