- cruise is dead
- Turbo Gaskets
- Tie Rod Needed
- electrical snafu
- Protection for his wife.
- WIF/WTS Lights On!
- O ring on throttle shaft, is it anything special?
- shops near no.aurora ILL
- Engine wiring Diagram
- how to identify which ve i have
- what other turbo's will fit
- Best way to set up a fuel pressure guage?
- Emissions
- Bellhousing Adapter
- Can Anyone ID these Injectors?
- Quieter with KSB on??
- Can I buy a NEW VE pump?
- JLeonard's Birthday
- What to do about front springs on 93 W250?
- 1992 W350
- Quick timing question
- how old are the guys useing this site ?
- Testing blower resistor block
- New member...thanks...
- Where to buy ISSPRO tach adaptor?
- Dodge Trans.
- Happy Thanksgiving
- Another one bites the dust (VE Pump)
- Engine won't shut off!
- 1st Gen Power Curve
- 2nd Gen Center caps on 1st Gen?
- rotella 0W-40 Full Sythetic ok ?
- piston lift pump pressure ?'s
- 89 first gen have no post-heat
- Can someone please explain "turbo surge" to me?
- extended cab rear seat
- hummer H2 wheels on a first gen?
- Will it work?
- Timing gear puller for VE pump
- 1992 Auto trans ?
- Sensor in head of Drivers side of Motor
- Need help with voltage drop...
- truck plumbing (brakes and fuel)
- Rear Brake Follies-Tugboatphil pays a visit
- VE pump leak
- truck mayday
- First gen ambulance
- Need more power from my VE
- 5-Spd Getrag Noise?
- steering slop fixed
- best weight to put in bed of truck for winter traction?
- CAROLINA CUMMINS Calendar!!
- '93 trans?
- Stack prices
- Intercooler boots...
- That ring around the key: lit or not?
- Cummins Display Panel
- Engine stalls on backward braking
- 4x4 Indicator
- 2006 wheels on a 1st gen ?
- Everybody on ALL the TDR Forums
- How much does our bed weigh?
- Holset 16? or not..
- Those of you with flatbeds...
- Borgeson Steering Shaft Installed
- Where should I buy my PODs from?
- Still more on sound deadening.....
- where can i get a new ksb
- Stuck exhaust housing
- Will it fit?
- 2nd gen 94-99 Chrome Wheels on a 1st gen?
- Another Flatbed question Cab to Bed Clearance
- Which injectors?
- Oil feed Line
- value on a very clean '93?
- does anyone have the measuremants for
- Tires and Wheels
- Floor mats and fuel injector lines
- A simple VE pump question (I hope)
- what guages to buy and where... ?
- New Fuel
- new rotors?
- Part interchange?
- Spring Frame Mount
- Question on a flatbed install and frame strength.
- Suspension ???
- Help! Need heads for my 89 Gas Truck
- Looking for Dana 80 4.10
- Vents in doors?
- If anybody celebrates the 10th of Nov., Happybirthday.
- 16cm Turbo Housing
- Looking at another 1st gen what to expect?
- Engine Missing, Hard to Start, Dying, etc.
- stronger getrag clutch
- Slow crank with new battery
- Had brain dump need VE expert
- VE rebuild
- door locks hanging up?
- FSM electrical
- The leaking VE pump syndrom???
- Slight problem(s)
- More charging ?
- My truck is gone.Boy do I have a story.(long post)
- Lowly 103 pump
- Need 21 cm Housing
- New head gasket job
- Crew cab on ebay, parts truck!
- Alternator charging ?
- H1C vc WH1C part interchange?'s
- Trans problem or "computer"
- Dually rears
- factory door hinge install
- Crack in the Torque Converter?
- New first gen
- The carnage inside my injection pump
- -5 and truck dosn't crank fast enough to start
- Trucks dying
- Windshield leaking
- Resume/Accel Switch or clockspring?
- what do I do after biodiesel gelling?
- My wacky dashboard compass…
- Injector pump leak
- Firestone Destination M/T tires
- Fuel Tank Suction and Return Fittings - Help
- Fuel system pics part 2
- ANyone have a 12cm housing?
- getting rid of the pcm ?'s
- 1025ccr
- went to the track lastnight.....
- Looking to buy a 93, issues?
- best recommendations for improvements ?
- Driveline Vibration 40mph-50mph Wow
- Body's Done, but missing a Front Bumper and Grill Guard
- 1991 w250...What is it worth?
- It's Deja Moo all over again (brakes)
- Bad Influence !!!
- Where to buy fuel additive?
- getrag trans
- 727 3-speed transmission
- ULSD has anyone noticed anything yet?
- Grill bra/cover?
- Need a Guinea Pig
- throttle linkage replacement ball,and sockets
- Identify this housing.
- I have part numbers
- Getrag failure - what to do?
- Clutch Recomendations.
- How to Test Drive Getrag to Verify Function?
- Ulsdf
- Baldwin Filters
- Rear View Mirror Glass.
- Window motor rebuild
- POD length?
- first generation cummings turbo boast
- How Much Horse Power Before Issues?
- Crack in Cylinder Head
- Low power, again
- grill
- Getrag bearings from Ebay?
- 3.07 locker (snow is comming
- Detroit Locker
- 1991 dana 70 rear
- 12v Rotary To P Pump
- 92 518 slipping 2nd into 3rd help !!!
- 727/518 adjustments
- Anybody have a pic of their firewall
- 1991 w250
- 727 truck question
- No charging
- cool down timer?
- cool down timer?
- Birthday:October 20, 1976
- Stupid question...
- Anyone know?
- leaf spring pins
- leaf spring pins
- Battery size ?
- Stuck rear axles.
- Problem with pod injectors..
- 1st Gen body parts
- now whats happening?
- How much space should there be between the front spring and the rubber bump stop?
- Ran out of fuel, procedure needed to restart please
- no pedal after rear disc conv
- Club Cab
- Need Help! Battery Charging/Alternator problem
- Air horns
- blueish smoke
- My New Intake & Intercooler Tubes
- What's it worth
- Rebuilt FI pump for early 91
- Thermostat part #
- Winch bumpers revisited
- Fuel system driving me nuts among other things
- Do I need PCM??
- Max Tire size ?
- bad smoke, help please 93 d350
- It's Alive!!!
- Set up advice
- My 1st gen on ebay
- VE drive key
- BGilbert: A big filter, a big filter.
- P-Pump convertion?
- 727 Auto
- base line settings for pump
- where are the best deals for replacement seats for 1st gen
- '98.5 truck/ '92 engine/ Tach problem
- looking for a tac. would like to see what rpms im at
- Grease on inside of window...heat too...
- What will make my brake pedal rock hard after new booster?
- How's this Getrag core look?
- How hard would it be....
- PDR 40/14 0n 1 gen
- 4x4 Bilstein shock question
- Scored @ Pick-n-Pull.
- So My Truck Died Today...
- 518 upgrade
- Tranny Fluid First Change
- looking at 92 250 club 4x4
- Low Dyno #'s!!!!!!!!!!!!!!!!!!!!!!
- jimmy's alive!
- 2wd alignment specs
- Speedo Troubles again
- Throttle linkage ?
- MAP Effienciency for Turbos--> New 54CM Compressor Wheel is ON (NON I/C)
- Air Cleaner Options for Early 91
- low boost problem solved..
- K&N Air Filter v.s. Replacement Elements?
- intercooler piping
- Found Bed - Now Need Floor/Cab Supports
- New to me, front end story
- fuse for taillights on my 92
- Auxillary Fuel Tank
- Anyone try bigger injection lines ?
- Broken piece inside Getrag
- More on Truck 'making' oil
- 93 smoke with 99% biodiesel
- Fix for dangling maplight?
- Where to get new bed floor?
- Water In Fuel
- Tail Gate parts
- replaceing a fuel filter
- power brake booster
- 92 W250 loose steering column
- Calling out BGilbert??
- Truck "making" oil?? Help
- Not as good as Jay but.....
- lightest weight rims?
- Still Chasing That vibration
- Help in S.C. with leaky inj. pump