- Leaking box
- Bad memory... who offered me that tach?
- 4 inch exhaust
- Steering Stabilizer/tach Search
- After Market body parts opinions
- Getrag rebuild
- Head Gasket Leak Help
- GVWR - 1st gen dually?
- What do you think of this truck?
- Blue-white smoke, engine misses
- Ok guys, it's that time again.....
- Billet Grille
- My Photo Album is Posted
- Vent recess mount by glovebox
- New Lift Pump Number.
- Bed Wobble
- Tach
- Selling; What's it worth?
- New injectors are in
- Engine took a 3 1/2 foot drop
- Well, it's not a RR exhaust but it'll have to do...
- NV5600 In My First Gen Just Completed!
- Benefits of Divorced Case
- cold starting issue
- 1 st Gen gone
- I'm SOOOO &#*$@ tired of inferior parts
- Drove my old pickup yesterday
- used turbos
- Fuel pressure regulator
- New Member
- Cheap '93 D250 LE CC CTD in Michigan
- Seat Swap (not Mopar)
- Heh, Heh, Heh.....
- 16cm housing
- 727 bolt pattern?
- Trans Dilemma
- Why not to go with smaller than 16cm housings
- For you guys with the 6" rear springs
- Free Power From The VE Pump
- kdp
- sagging front springs
- Soydiesel
- First genners must be nuckin' futs
- Frame to steeing re-inforcement
- Vibration in the go pedal
- Alaska trip article
- diesel song
- grid heater problems...AGAIN
- pyro and boost?
- noises in dash
- AAAAAAAAaaaaaaa... Egadssss....
- More on t-case fix
- Clutch Switch
- No Shocks
- how much for wheel bearings and seals??
- headgasket
- headgasket
- Source for steering control arm
- My headlights suck
- Tailgate Locks???????
- injectors
- 518 overdrive and 3:07 rear
- lowering back end of truck
- Need specs from a First Gen sales brochure
- Dana 71
- brakes
- HELP... Does anyone have layout skills???
- Used P-Pump
- Why can't anything be simple...
- exhaust housing
- Clutch safety switch
- Switching to Synthetic?
- Rotella DFA Anyone using this?
- How muchis too much?
- Injection pump : (
- winter driving
- New TDR chapter
- Happy New Year to all
- launch shudder...cured?
- Grille Guard
- D-350 rear brake question
- turbo oil supply line
- Dodge/Cummins backcountry reliability
- '01 tailpipe on '93
- Dana 60 I.D.
- Limited Slip upgrade recommendations
- Cooling system pushing out coolant
- Polyurethane bushings
- Baby needs to bye bye
- Dana 70 question
- Alternator Question
- injector swap
- Leave the engine running
- Dually rear end swap?
- mirrors for towing?
- Tiger Tips?
- Any 1st genners with an HX 40 ?
- Wet behind the doors...
- what turbo came on a '90
- dana 44 front axle ? would you guys use one ?
- noise + vibration
- Martha Stewarts tips for rednecks
- Injection Problem
- Need Injetion Pump Help
- Lift pump oil leak.
- VE pump + cut delivery valves = ?
- Power Steering Help
- Merry Christmas And Happy New Year...
- NP205 needed
- How much horsepower
- Performance VE pump
- supercharger
- getrag
- Clutch pedal
- Call me cheep but..
- 93 Dodge fuse block location
- Steering column squeek and sliding rear window
- Post here for Porting and Polishing thread.
- Air Compressor
- How to port and polish: by and with permisison of hdm48
- Brake Question.
- New Truck
- One problem right after the other
- Oil Leak
- Do they have a maintenance kit?
- Fass? Fuel Preparator?
- Message for the Pastor
- Rear Axle Swap?
- afe Proguard 7
- Coolant leak
- fender flares
- Tailgate security
- Which Turbine Housing?????
- Moving on
- ? on HTT Stage 3 upgrade/turbine wheel and shaft removal
- high idle mechanism
- Airflow increases
- Thanks and a Ball joint question
- Seal installation
- No go from 727
- Seal Driver
- block heater maybe dead?
- First gen Birthday
- Another Getrag bites the dust....
- won $250.00 @peirs, need help spending it
- Cummins B3.9 & B5.9 Op & Maint Mnl Recommended?
- EDM injectors- Part I
- gauges on the net!!!
- Old Smoky Mount
- Where to install Tee.
- 92 D250 Rim Width
- oil light
- Borgeson quality concerns
- Anyone have a dial indicator?
- Anybody got a control arm? MOPAR doesn't!!
- Turbo Whistle
- water temperature gauge
- Wiring Question
- Since we're talking gauges...
- Thumbs Down Award
- speedo gearing
- Worth bombing ?
- NOWEL (HVAC) THOMAS..HONORARY MEMBER-1st GEN GROUP. OPEN FOR POSTING
- 1st gen gauges????
- 1/4 mile times for 1rst gens
- Optional tire sizes
- 92 Dually Bed
- Lack of PS in the AM
- coolant woes
- Bigger tires on a dually?
- Turbo Bark
- Are we all just SOL for anything dodge now?
- Tailgate from a '80s truck
- 2003 - Not my year
- Redheaded Cummins
- Geno's Make a Wish
- RWAL part number?
- Compression Numbers?
- Frame Crossmember Rivets Loose.....
- 2nd Gen Intake Manifold
- Nowel Thomas' passing....please give feedback..
- Factory Tachs
- Did I screw up this turbo?
- Twin Turbos
- vibration /motor mts
- Cleaning the engine compartment
- Before I get ahead of myself...
- plowin'
- A little more discussion of 6-speed conversions?
- New member question.
- What should be my next step?
- intercooler recore/ buy new?
- Did Dodge make a '93 or 1st gen Crew Cab?
- Fuel heater
- "Growling" Front Axle (W250/4x4)
- Problems past 100K miles
- alternator tach install
- Which injectors should I get?
- Sunday, December 7th....................
- Engine shutdown
- '91 350 at auction
- Will 2nd gen wheels fit on 1st gen
- BOMB Report
- Cummins power emblem
- Governor spring and high idle screw
- injection pump
- injector?
- Can you make 2nd gen injectors fit?
- air cleaner element best one
- DD3 vs POD
- Father following in Son's foot er truck steps?
- EDM Injectors
- hellwig anti sway
- New coil springs
- Please say a prayer for HVAC...
- Rear axle maintenance
- Driveshaft-mounted disc park brake?
- So what's this really worth?
- Getrag vs NV4500
- Paint code
- Upper ball joints
- anyone know a good place to get dually rims? used/new
- Does any one know about a front end modifacation for a 2wd dually?
- 250 vs. 350
- Favor plz, instrument panel width?
- Test
- how to istall gauges
- clutch
- towing and temps question
- Has anyone been able to cram 5" under there yet?
- Another guy (me) having cruise troubles
- Anyone had this problem before?
- Transfer Case & Axle?????
- Grease for Dana 60?
- Am I nuts?
- How much HP will a stock clutch hold?
- Rear Axle Interchange?
- More injection pump woes...
- How much fuel with stock injectors?
- Anyone need..........
- Magazine Project Truck
- might make you guys smile a bit
- Retrofit a 1st Gen?
- WHY!?!? (1st gen baby-rant)
- my truck list
- 4x4 or 4x2
- coolant pipes, steering leek
- prescott,AZ
- Tps Vendor
- Salt Season is almost here