- Bio in first gen!
- truck starts funny, if at all
- Factory flexplate #?
- Replacing dash pad
- Steering Box Gear Backlash?
- 1989 d 250
- 4inch downtube For 1st gen--Where can I get one?
- What do ya think?
- factory tach$$$$$$$$$$
- What were the original MPG estimates for our trucks
- Wheel Bolts - problem with Mags
- looking for a Brian Block 14mm pump head for rotory
- Wait To Start Light *BLINKS*
- Dtt Torque Convertor
- How much are they going for? Dana 70's
- how much is it worth ?
- Rear Brake Shoe Size?
- New pump Question
- Diaphram lift pump failed
- Installing New Front Springs On My W250
- Power Steering Hi Pressure Hose O Ring Size?
- Grid heater relays
- Pyro Probe install
- Coolant change in 93 Cummins
- need getrag help
- Looking for home brew fuel system
- Tranny question
- Transmission ID
- Wheels And Rims
- 1st gen, 2nd gen manifolds the same?
- Happy Easter
- Short lived shut off solenoid!
- Oil leak help
- High Accelerator Pedal Effort
- Sheared woodruff key
- source for dually fenders??
- Good Shop Alert!!!!
- electrical gremlins, wipers, alternater
- Does anyone have the stock sachs clutch kit part #?
- LE tailgate Same for 250 and 350
- Starter mounting bolt size?
- Replacement Radiator
- Headshot zod hits the big 40
- POD's are in!!
- Flexplate
- 3.07's in a Getrag 4x4 truck?? Who's done it and what do you think?
- How much do flatbeds go for?
- Which type of clutch for a truck w/ an NV4500/AA kit?
- Sachs replacement clutch still the way to go? Anyone tried the ones on ebay?
- getrag stuck in gear
- New Treads!
- Air Filters
- Tool Question
- front axle
- Getrag parts
- Getrag seal
- '90 CTD Mileage?
- 91.5 Automatic
- Need hood release, where to get?
- need dana 80 rear disc or drum 410
- Salt help?
- Needed: D70 rear axle!!
- can this swap be done?
- Getrag Disassembly.
- steering sector leak
- calipers
- Turn on the Screw
- PCM for a '92
- contoller for 96 tranny in 89 truck
- No start after VE resealed for fuel leak
- Coolant On The Head
- getrag
- Anyone have an extra light socket?
- Does anyone do ignition timing around ny/nj/ct
- In Chassis Rebuild
- Pre-Summer Question
- fuel leak problem
- is it worth it?
- stock sized exhaust with good bends?
- Turn signal, no cancel>left only...
- 89 oil pressure slow coming up
- more fuel
- Getrag OOS
- 2nd Gen flexplate
- fuel pump lever
- Good buy, or not?
- I think my turbo's mute!
- Stake pocket tie downs?
- which dana 70 yoke to get?
- ongoing fuel problem
- "1st gen cummins" dyno video on Youtube
- Fuel leak on full adjustment screw
- Getrag Down!
- 330 Injectors
- smoke screw results
- which injectors are these
- asa modified intake questions
- Battery Drain??
- boobi trap my tool box
- Gen One potential
- nv4500 rebuild.
- Has Anyone passed the new stomp test?
- pump adjustment gone bad, could use a good diesel shop near Fresno ca
- What Parts Needed To Remount Body?
- inj.pump leak revisited
- dynoday
- Oil Pan Gasket
- running very rough
- DynaBeads
- possible turbo chatter after switching ex housings
- Changing Exhaust Manifolds
- Water leaking in the cab
- are any of the 518 trans luck up trans
- Gone but not forgotten
- New IP
- Help me with this problem
- twins???
- Long live the Getrag!
- Which 1st generation year to buy?
- Rear main seal question.
- Airing up dual tires
- New supply hose made a WOLRD of difference
- injector pump leak
- Adding a relay to the Heater Blower switch
- More Cruise Control Woes
- Poll: What lube are you guys running in your Getrags?
- Motor Oil, cj vs ci
- Has anyone had a BD auto trans installed?
- pump adjustments
- NV5600 Back Up Sensor For 1st gen
- Fixed my Water in Fuel sensor
- RIP PGunther
- 1992 CTD Dually Fender
- Blew input seal on steering box
- Heavy Duty front bumper (ranch-hand)
- Sparks/exhaust
- Is this normal?
- 19.5s for 1st gen
- Need Pics!
- How hard to take shifter off of Getrag to overfill?
- Amsoil Air filters-Where?
- Thanks for the information
- torquing turbo together, brass fitting for boost?
- Engine stumbles when cold at idle
- cummins / nv4500 weight
- turbo,exhaust,fuel pump adjustments sequence?
- Engine shutting off?
- Getrag temps and general nonsense
- Stanadyne performance formula...
- Philp, any progress on your exhaust?
- broken head pipe
- are all 518 trannys the same??
- Kink in AFC line
- U-bolt size for 1990 Ram W350?
- KDP Help El Paso Texas anyone????
- easy horse power/fuel economy?
- Turbo Questions
- less boost with intercooler
- Trade 6" rear blocks for 4"?
- 3rd gen turbo?
- 92-93' Color matching grille
- Electrical Trouble
- tps switch
- high pressure fuel line clamps/holders
- Some Balwin Filters
- I love my first gen
- What's it worth
- sputter, sputter...mort
- Replacing Fuel Tank Sending unit
- Shut Off
- oil filter
- 14mm VE roll call
- Elec Fuel Pump on a 1st Gen ???
- new style rims need spacers..
- Pump it up!
- 1st Gen 4x4 questions
- New user 5 spd ??
- battery
- HOW TO remove fuel/water separator drain?
- Shuddering Sensation
- Stickies are now in FAQ Forum
- LSD Still availiable ?
- Headlight switch and plug
- Installation of Bug Mesh Over Condensor/Radiator?
- Smokehouse Diesel now includes UPS Delivery Vans
- New cummins owner,?
- Front Brakes
- Shifter problems
- Steering damper?
- When tot ighten the bolts
- HVAC issues
- takeing a silencer ring out of the turbo help please
- ISS tach "pigtail" ?
- Broken Dually Fenders
- what it looked like as we landed up side down
- D350 performance
- Fuel guage, Ohm's?
- block heater/seals/door
- stuck in 4 high
- EBay $15,000+
- Getting PODs
- Noisy Lifters?
- POD's w/ a 62/12 on a 5 sp truck?
- any ideas/part numbers for 93 mud flaps?
- Lifting front end
- Damage from being towed?
- 92 1 ton auto, seems to be running hot...please help !
- Piers Head
- Engine Stumbles After Starting
- Stereo and 1993 Options
- ANy good alignment shops locally?
- Cost to switch ring gears
- what tire size will fit
- 91.5 OD problem
- exhaust questions
- ksb types?
- Bearing Pics
- Getrag not gett'in-r-done
- how much boost can stock valvesprings hold
- anyone close to chicago to help with timing
- difference between 1st and 2nd gen exh manifolds
- Bad day...Dyno
- Opening the Nozzles.....How Big?
- Isspro tach that geno's sells.
- 89 On ebay
- Anyone looking for parts?
- LH vent window
- need to rotate turbo outlet
- Tire Sizes
- Injectors
- 30K on front brakes...
- Question for y'all with stock automatics
- 3200 gov spring 1 left
- Voltage regulator
- skobylenski's first gen on the front page!
- VE parts help.
- Info on Banks Turbo
- ULSD 1 Cummins 0
- Injector pump gear??????
- stock turbo
- Check this out
- Intake Manifolds and mpg
- Ventura County Mechanic?
- You guys know anything about the 6bt's in UPS trucks?
- fuel pressure...which behavior is correct?
- pics!!!!!!
- Body Parts: Availability
- RPM drop when cold??
- Axle question?
- WEIRD happenings in the radiator