- '03 Serpentine Belt Part Numer???
- Van Aaken box P0606 codes
- 827 miles per tank with 315 tires & Edge EZ
- is there warranty issues w/gauges?
- engine knock/bad injector.
- Exxon diesel mixed with gas
- Anyone want to chime in?
- My Engine Died
- Twin turbos, Injectors, Chip?
- Long bed or short bed?
- Poll related to 48RE final shift.
- TST Reflashed
- Fleetguard Air Filter Part #??
- HELP! - Turbo Noise/Clatter -
- Drivetrain slack - Is rearend going bad?
- Transmission repair, new clutch WOW!!
- Mechanic needed injector knock
- 80-100hp/no EGT issues/4-6mpg> miracle inj installed Friday
- New Tranny Pan from DPP!!!
- Think I have a POS
- Trans Fluid Level Question
- Launch Shudder
- bad injector? need input...
- Needed!!! 250hp and 305hp 03-04 Trucks In DFW
- rear drive shaft again........
- What The High Egt For The 600
- What do you do with the airbox plug?
- Is new pan gasket required for 48RE?
- Has anyone used both auxillary oil ports?
- when to change my oil filter??
- Black Smoke?
- How do I drive with the Mystery Switch?
- Transfer case ?s on '05
- Stacked EZ on a 600????????
- Keyless entry stopped working
- Needing a new clutch. Which one?
- Which one is easier to bomb?
- 04.5 Edge EZ Istalled today
- air filter question
- Trans temp Probe placement
- Very slow acceleration until 2000 rpm then zoom, is this normal?
- 04.5 Launch Shutter & Vibration
- fuel pressure #'s stock and modified
- A-pillar dual gauge mount
- How much HP do gauges add?
- An "EXHAUSTING" Question
- Injector Question
- My oil leak question?
- slave or master cylinder
- Buying a 3rd gen truck...
- which synthetic oil?
- Rear Main Oil Leak?
- Clutch or somethin' else?
- Why do you use Synthetic Oil?
- anyone successfully reprogram a 305 to a 325?
- blown dodge at 3 miles!
- Gauge installation
- EGR on Cummins 600?
- Antifreeze leak from exhaust side of head???
- Pass. side air bag switch
- Transfer pump failure??
- intake manifold
- Belt Shredding
- Cummins Injectors
- Carrier bearing??? Where can I get one fast?
- K&N FIPK good or bad???
- check this out
- Oil filter sandwich adapter?
- Diesel flush before oil change: Fact or fiction?
- Transmission cooler lines
- Engine Codes
- First 2005 Here On Lot!! -- 8-13-04
- Will you lose updates by Disconnecting Battery?
- Screwed Up!
- Anyone really pushing over 500 RWHP?
- TST Cummins vs Mustang Sally
- Which rear end oil?
- Combo Gauges
- Auxilliary Transmission :MPG?
- 2003
- fuel injector noise
- 75,000 and counting
- Metal piston cooling nozzles
- No/Little boost pressure
- 2003
- Can you run an 04 without a muffler??
- Oil drips - '04.5 CTD
- Newbie Question..When can I
- Oil filter replaced without filling with oil?
- need help on injectors
- NV5600 2002 vs 2003-4?
- clutch shudder ??
- A Big Thank You To TDR Magazine!
- Exhaust Temps
- Mechanical vs Electrical oil pressure gauge?
- Dealer wont sell jacobs ehaust brake?
- What about these TSB's
- 4 inch exhaust
- Coolant Loss?
- Red Line MTL question
- Dyno with TST
- TST instructions
- which tracrite diff comes in the rear of the CTD trucks?
- 5 speed auto?
- 600 is smoking and knocking occasionally
- Tranny Filter Source (other than dealer)
- Difference between a 47re and a 48re?
- Reinstalled motor, getting about 17 codes on dash, and runs lousy
- fuel filter changing questions...
- Oil weights
- exhaust manifold??
- Where to Buy Oil Filter?
- NV5600 and diferential fluid change
- Engine Break-in/TST Upgrade?
- new turbo soon for the TST
- 3.73 or 4.10 with automatic and some towing?
- Installed powermaxcr,engine light on and codes
- Smoke from under right fender
- 03' H.O. pusher pump
- Would someone look up a part number for me?
- Bummer!
- Why Zero Throttle?
- HELP! Need info 2004.5 vs 2005
- Did I hit reverse?!?
- Engine changes for 2005?
- Looking for Advise on Vibration at 70mph
- Need help changing front drivers side axle U-joint
- Black oil on a 2004.5
- Tranny temp??
- I made 100K then..................
- Fluid leak - wet spot on frame
- TST ordered. Installation Questions:
- High Idler
- Codes??
- 48re thrust washer concern
- vibration @ 1700 RPM
- Rear End Noise
- Dazed and confused
- Fuel Economy
- Does Your Jacobs Ebrake Cause a "Whistle Sound" at the End of Your Exhaust Pipe?
- First 500 Miles....
- Pacbrake Compressor Noise and Crusie Control Disconnect
- Lesson Learned with new box! (short story)
- EGT drop. NOT REALLY
- How to get better fuel Mileage ???????
- egt guages
- Will my 01 filters will fit my 04.5 motor?
- newbe boost question
- Headlight thunk
- Edge EZ
- who has a BD Short Shifter?
- K&N FIPK2 System - need AFE filter
- Yes I still maintain the fueling box summary
- EZ secret
- ?s on synthetic oil change over
- The answer to straight pipe and muffer!
- New HTB2
- Motoblue Exhaust
- AC Clutch noise
- Damn engine knock (with sound clip)
- Where to buy Fuel?
- What to do next??
- What mods would you reccomend?
- Diesel smell in AC
- Magna-Flow exhaust ???
- used one of those fancy oil filter wrenches from the bottom....
- stock engine horsepower?
- One more differental topic!
- Cummins L10 turbo...yes or no?
- Scotty Ram Air 3 Filter...
- TST Box Questions
- Tranny Service
- Dynoed TST on 600
- twins with TST
- bosch pump cool cutaway
- Mopar Orders Stop to Installation of Ebrakes Until Further Notice?
- Fuel Transfer pump problem?
- greddy guages 52MM
- Ford and Chevs w/auto ?
- 04.5 with 4k miles. Belt shredded
- Straight Piped Like IT BUT
- How Can I find Rear axel ratio?
- Tranny & pinion bearings
- Diesel tuning and operating theory book?
- Big three pull off
- overflow valve on the 3rd gens
- servide manual - fuel system priming....
- First oil change on NV5600
- Cheap Cruise Control
- tst questions
- Tranny acting wierd
- Grease
- Straight pipe Drone?
- How to telling if 04 or 04.5
- '03 block heater assy
- Slight , single " Knock".....not bad, but need opinions!
- EGT probe install
- Mag/Hytec rear cover and 315 spare??
- Cummins installed wrong oil filter
- 4" DPPI Exhaust ???
- Neighbor Freaks Out
- 5500
- Engine warm up in cold climate?
- Transmission Temp. Gauge Help
- It's the wind, not the load!
- Edge Boxes
- my experience with trans temps and gauges
- Max safe boost for stock HPCR head gasket?
- Bad Injector-Can I drive it.
- Question regarding 48RE torque converter change.
- "Houston, we have noise reduction!"
- Simple turbo boost mod
- How to stop loud screech at shutdown
- AFE Drop in filters
- Castrol Syntorq LT SAE 75W-85W GL-4 okay to use in NV4500?
- fuel retun lines
- Edge EZ settings
- Rear axle Gear Ratios
- Who is towing with 3.73’s?
- Average Fuel Economy Readout PROBLEM
- new clutch
- edge boxes
- Clutch/Transmission noise 6spd?
- Sound on cold start
- NV5600 and American 4" rearend temps
- 48RE Thrust Washers
- Engine wants to quit running after cold start
- 04.5 High Idle Help
- Dr. Performance Power Module
- frantz return line location?
- Detectable chips: yes or no?
- turbo updates
- HELP ! geno's brass drain plug snaps inside my oil pan !
- Opinions/experiences wanted on a VA Smartbox C3.2
- Donaldson muffler
- TST: Digital guages or not?
- Engine cutback during acceleration....
- Tubo Lag & 48re Question
- Hunting idle and TSB for cold weather idle?
- turbo to manifold gasket
- AFE proguard 7 stock replacement air filter
- Finally found it
- Repaired 48RE
- 5600 gear nob twisting?
- Exh. Brake Pac, BD, or Jacobs?
- AFE Pro Guard 7 kit for the 600...
- Anybody have dyno numbers for a "600" with a banks 6 gun?
- Humbled Powerjoke buddy
- PROLONG anybody use this
- Looking for good advice