- Holly Blue not the Answer: For Me(VERY LONG)
- Smarty Timing
- used edge ez
- Help me, I have fallen and can't get up
- starter Bump???
- Calling all Trannyheads!
- Oil breather Mess
- High idle option?
- What is boost?
- 5" muffler?
- Run Away !!!
- Edge Mileage Max
- Slight miss
- Temps up pulling the slightest grade
- Engine blow-by bottle
- Transfer Case Fluid Level
- fuel filter help the truck starts when hot cold hard starts
- Defuel ??
- Fuel only box
- El Paso, TX or Las Cruces, NM shops for lift pump issues?
- Request input on air filter experiment.
- Low Fuel Pressure, changed fuel filter & at first OK, then low fp again
- Hard start - with a twist!
- Loss of Power / Black Smoke
- Truck loosing power
- Low Power in a 98 24v dually
- No more warranty!
- Its DEAD! And I need help!
- FASS & EGT / Verify EGT readings
- Whistlin Turbos
- Bad Vibration
- Transfer pump ?S
- VP44 questions
- Oil pan gasket?
- P1693 Code Thrown Under "Hard" Acceleration
- VP-44 and low fuel pressure when running
- Smaller Twins
- squealing noise
- truck won't start after filter change. help!
- Anyone running a Super "B"?
- changed chips top end of rpm not right
- Best Deal Lift Pump
- Need bigger turbo
- No fuel
- Auto Trans voltage loss problems
- top boost?
- High Idle ramp-up @ 31F?
- I need underhood fusebox chart.
- Installed Frantz TP Bypass today but...
- Turbo Chuffing
- Fluidampr
- Who Sells Bluechip Products?
- VP-44, lift pumps, fuel level and turbo oh my
- FASS 150/150 at 20 psi
- low power 24v
- Fuel gauge stuck at 3/4
- Timing!!!!!
- Question on 35/40 turbo
- Trans question
- How to Smoke?
- 47RE Transmission Weight?
- 3rd gen oil/fuel filters?
- Lift pump electrical problem?
- Now What ?
- Draw Straw II
- how are you going to heat your fuel this year??
- Cleaning up after leaky vacuum pump seal replaced
- Who has the best VP44 replacement?/
- reset 0216 code
- What did I do?
- Easy start cold, Hard start warm??
- Comp wiring questions
- Got Surprized today
- What did I screw up? Opinions please!!!!
- Hydrogen Boost ??
- Lock/Unlock Torque Converter
- how to reach 700hp without NOS/Propane
- HY as twin
- For EGidley
- Smarty high idle?
- Smarty and Banks not fueling!!!!!!
- Losing fuel prime
- Clutch life.
- Would an HX-35 be an upgrade for an 01 auto?
- Tag
- Shorted Generator
- looking for timeing bolt cover
- Walbro Lift Pump Users
- best price on a f a s s or airdog
- Throttle pedal/linkage tight when it gets cold.
- 98.5 died today
- Banks Smart Lock and Exhaust Brake
- '00 24valve cut out.
- Fuel Pressure Question
- leaky vacuum pump
- Power Issues
- Where does the Attitude read the fuel temp?
- Troubleshooting the VP-44 - as quoted from Blue Chip
- VP-44 cover bolts
- Trans. jolt
- ISB 24 Valve
- ABS light?
- Turbo Question
- Haunted cummins
- cam position sensor
- need to know on turbo
- Help! Truck Shut Off & Won't Start
- VP 44 Reliability?
- New Turbo, now exhaust question?
- HPFP Install
- "55" Block
- Rear main seal leak
- Warranty?
- need new parts dont want to go to the dealer
- 216 and no dead pedal
- Fass Pressure ???
- Dana 80 applications
- Buying Edge Juice Attitude questions,,,
- FASS LP Not Running
- Head stud torqe
- Friday burnout!!!!!!
- What is the size of the H.O. TURBO?
- Engine miss fire
- Low Fuel Psi
- AirDog Installed
- Plastic piston cooling nozzles
- Youngin got wrong truck...
- Info on best dyno results
- Auto Tranny pan torque spec?
- Tractor Pull Pics
- vp44
- Fass Instal
- CKP/CMP troubles
- ATS Aurora 3000 turbo
- Diesel Nut Performance in Elk Grove CA?
- high temp &egt
- Lost power, Lost boost, Mileage decreased
- Installing Fuel psi gauge
- new auto tranny problem
- Austin Texas Mechanic Referrals
- shelled engine
- help I've got a charging problem
- What is needed?
- squeak, squeal or chatter - NV5600
- + 148hp & 267tq from tapping the VP
- No first gear/auto tranny
- Just installed Edge Drag Comp
- What's the Stock Turbo on my 99
- Here's your chance....
- good for one 200k plate
- 200k today folks
- fuel mileage is off
- Engine Stumbles and Dies Occasionally
- Performance after valve adjustment
- FASS Question
- hard start fixd!!!!!!
- Puzzling problem
- can you still get a 70$ "campaign" pump?
- Good Transmission Shop-- Portland OR.
- FINALLY!!!! Some one puts an end to Carter!!
- Best Manual For 99' 24 valve Repair Work
- where's the towing power?
- Fuel system question
- where's the towing power?
- TIP for guys needing to change/clean the IAT
- Valve body
- HX-35 Housing with HX-40 outlet
- Building a bumper... what about cooling?
- EGTs High When Towing a Load
- Mystery Switch
- Edge Comp and Smarty?
- a little smoke for ya
- air dog install
- just need to know
- What is the single turbo on a Cat in a kenworth
- TPS and throttle bucking
- How many have seen kdp on 24 valve truck
- hi
- Oil Pressure Question
- Power Steering System Bleeding
- 24 Valve Overhead Adjustment
- what fuel mods. do i need?
- Finally got my truck back
- What's in the resonator?
- B20 Diesel
- IAT sensor
- oil leak @ drain plug
- Ball joints and fuel gauge
- ctd injectors
- Edge Juice w/ Auto tranny... minimum upgrades?
- AIR DOG install
- Fuel Pre-Filter
- FASS pump installed WOW
- crapy fuel milage need help figuring why
- Post turbo exhaust clamp
- thinking of doing a cam
- 4 wheel indicator light
- Grid Heater Question
- vp44
- SMARTY Adjustable speed limiter. Where to download?
- Aluminized and Stainless Exhuast???
- code p1688 engine shutdown
- Backup Light Switch on the 5600
- what exactly does 'tapping the pump wire' do?
- Early ISB Factory Reflash?
- Grid Heaters keep cycling
- Out of fuel causes CEI and P1693
- Where to buy FASS?
- Transmission Temps?
- Edge Attitude Guage system Reliable
- Variable throttle response codes 1693 and 1488
- my working truck
- Fuel pressure loss, Stretched o-ring at filter
- Uderstanding Wastegate and boost adjustments??
- What other Mods. with Edge Juice W/Attitude?
- Dead '99
- Post your 1/4 mile and HP #'s...
- bypass OEM fuel filter/inline spin on
- 497 hp
- SB hydraulics upgrade instructions????
- Throwing couple codes since smarty (long)
- hesation from start
- Question about fuel pressure regulator install...
- Question on FASS Installation
- 01 with code p0230
- What ranges for guages?
- i need a fass by friday!!!!
- Serpentine belt issue...
- Towing EGTs. Don't want to kill the pistons
- Do these numbers sound right?
- damnfuel pump
- Cam Change, What would you pick?
- Hot Rod 44 ?'s
- Noise filter install
- 6-speed sawp question
- Truck is missing, What could it be?
- high idle ?
- Vp44 Cdrom?
- Schwitzer s2el-209 turbo
- Transmission temp sensor
- ecm needed
- 0122 code
- MAP and IAT fittings?
- Dead Pedal
- Proweld Transmission cooler Installed
- Novice "Chip" Question
- Oil leak at bell housing mate surface to block
- Radiator flush / Amsoil coolant
- Vapor Locked??
- whats wrong my truck?