- Trans getting hot now !
- where can I get a draw straw for my fass pump
- Intermittant Dead Pedal
- Tst Pm3
- Question about compression check and leakdown test.
- Dana 70 LSD question
- Help with problem?
- from 2 to 4
- Clutch Questions
- Another Towing Upgrade Question?
- Front axle will not go into 4 wheel drive
- RV275+EZ+Stock auto
- Bigger injection lines and tubes - when are they necessary?
- Bottle
- Fix for Oil Coming out on Steep Grades
- are these injectors for real?
- losing oil
- BHAF heatshield finally done!
- Life expectancy of HRVP?
- Help me pick a fuel system
- water in fuel?
- smokin like a train
- Anyone monitoring intake air temp?
- Dtc P0602
- where can I find the #53 on my block
- Glacier Diesel - GFS 392, Big Line & 2 Micron Filter
- Power Steering pump or Vac pump?
- 410's-Need Advice
- Need some help with my truck
- tEXAS dANA 80 REBUILDER NEEDED hELP!!
- Power Steering pump or Vac pump?
- warranty and relocated pump
- new cooler lines cause high engine temp
- what does code p1762 mean?
- Fleetguard Enviroguard crankcase vent
- vp-44 gear puller
- turbo going bad?
- Cracked Block
- EGT- what's normal
- Attention 600hp club!
- BHAF part numbers
- experienced surge & dead pedal (long)
- normal egt temperature
- High altitude problem — 9,000 ft.
- VP44 Problem or something else?
- looking for a 01 valve cover in shape
- what are some 2001 cummins performance mods
- Lift pump AND VP dead !!
- P-0122 HELP Please
- how much for a used Transfercase??
- Nice day to change the exhaust manifold
- Drain and Refill coolant system
- Posting Questions
- Replaced lift pump - low pressure
- Smarty pants
- transmission shift linkage seal replacment.
- Took It To Dealer Today
- Motor swap now code.
- Comp Problems
- Can I run w/ Snow Stage 2 turned off?
- Clutch question...
- Stage 1 water/meth on my truck??????
- battery relocation
- 2001 engine in a 99
- IN-Tank Lift Pump or Not
- Atf
- To tap or not to tap
- Code 0232
- cel on no codes what gives?
- Fuel pressure findings
- Turbo Pressure lost
- Trouble Code 779 per 504 Campaign
- By-pass oil filter
- Dyno Day video!
- Bhaf
- Zoom vs. SouthBend
- 02 power lose, any help
- Fuel Pressure Question
- Tip 4 less smoke on Smarty w/manual trans
- Opinions on Bosch 275s
- New Dyno #s 415 HP and 862 TQ
- Schied injectors?
- Tst PM3 upgrade?
- P0232 Code
- what could be the problem?
- Quick, help! Comp hook up question...
- TST PM3 problems
- Dyno run, Smart/Comp combo
- ABS and Brake light
- tips on longer engine life lets hear them
- WOW...Difference in injectors..
- is it a vp44 problem?
- Need help/ truck won't shut off!
- Looking at new transmissions.
- Injector body and tip question?
- Transmission vent tube location
- J-Hook question
- A Big ThankYou goes out to Farmboysdiesel!
- Which injectors should I use/HP guess?
- pressure solenoid and sensor
- Hy-35 or HX-35
- question for anyone
- Need advise/suggestion's on 5" sound!
- Put Edge Comp on friend's 99 - wheres the power??
- hard start ??????
- Auto Trans / Pacbrake Question
- Really wish I had 1 more gear for highway
- Diesel Dynamic injectors
- Glacier Installation
- Banks System
- Trans. Slipping
- 5.9l 24 valve timing gear housing guide pin
- cam?
- Comp box ????
- Still Hot!! ??? Help Guys
- Joined the 53 club today
- Differences between an HX and HY??
- VP 44 Gone Again
- kdp on 24v?
- Lost boost under load
- Help,sick truck
- Dana 80 & MagHytec, how much oil?
- 525hp- advice needed.
- A few questions
- Flexalite 262 does anyone have one?
- Water Meth or Hybrid Turbo
- Super Chip No More Run
- Stranded in Michigan HELP
- What does Smarty leave behind?
- Drivetrain binding
- truck died
- 01 to 99, Edge Question
- Turbo Question
- Dana 80 pinion seal
- Huge thumbs up to Industrial Injection's Silver 62
- long sit no start
- Breather blow by
- How much power will stock Turbo handle?
- CEL with FASS
- edge attitude monitor unreadable
- 235HP California Edition
- Radiator Sealant
- Fuel filter / intank pump
- New Vp, mach 4, head work
- Lift pump recommendations
- slight miss at idle and hard start when hot
- Edge Attitude ???
- Tranny attempting to up-shift?
- SMARTY truck pulls harder at part throttle, help me find old posts
- Vp44??
- NV5600 Tranny Temp While Towing
- lock up switch
- Pacbrake or BD for auto
- Looking For A Good Looking Valve Cover 24v
- Oh No! Not ANOTHER Smarty Question!
- how to i.d. hot rod vp
- Is hose needed on FP sensor?
- Having the Dealer change my tire size
- Leaking connection at VP44
- Suncoast tranny installed.
- Cheapest performance gain for towing
- Vp44: Doing it myself. What tools needed?
- need one
- Smarty - "Error Unknown Software" ???
- What trany fluids are you running in your built trany?
- Aftermarket Lift pump/Pusher pump wiring??
- How efficient are the factory trany coolers??
- Yes I tried the search..Need 24v thermostat seal number
- 410 Rear End to a 355???
- jammer nozzels
- EDGE does GOOD by me so far(response to EDGE is junk)
- better milage for towing
- Edge Drag Comp...ever see this?
- stock 6spd. clutch
- Mach 5 injectors. Whos running them?
- valve adjustment on 2002 24v
- keeps down shifting
- intermittent dead pedal
- Blue smoke
- Cost of Diff. ratio change?
- New Tranny, Thanks Richard!
- Lost fuel pressure / cold weather/clogged filter?
- how often do turbos need overhauled?
- Get this!
- Do I need upgraded tranny lines?
- Lots of questions about the Cummins
- Turbo questions
- Coolant Hoses
- Where to locate the new LP????
- Torgue spec
- Blown Head Gasket??
- Edge Juice with Att or Smarty???
- I have a coolant question
- trans. won't downshift to first gear, please help
- piston coatings
- new truck(to me)
- White Smoke at start up
- wastegate troubles
- truck runs 20mph at full throttle!
- any ideas (p1690)
- any ideas (p1690)
- Truck died, no sputter, just quit..Need advice!!!
- I cant believe this! has this happened to you??
- Vegetable oil in fuel tank?
- who has changed VP 44 on their own
- Please compare Smarty/Edge Vs. Smarty/TST
- New Fuel not having appropriate Lubricates?
- Icebox manufacturing
- How long has your VP44 lasted with a tapped wire?
- Lookin' for a new one
- FASS + Smarty+ what setting???
- Torque Converter Cycling In and Out Again
- Clutch up-grade
- Need help picking a module
- 2000 2500 Newbie-FASS ?'s
- Dog ate my trucks wiring,Help!!
- EDGE products are junk.
- fuel pressure at idle and WOT on an 01
- Thanks to so many guage problem solved
- Engine Serial Number???
- Oil additives for CJ4 oil
- If VP44 Dies, Where to get it Towed...??
- Grid Heaters, are they really necessary?
- TST - Question
- Injector lines...how big?
- That's it !!! I'm done !!!
- NV4500 is Dodge Fluid the same as chevy?
- EFI live for the Cummins?
- NV-5600 cooler and filter
- Superchips and a powerpuck?? can he?
- smoke from crank case vent tube
- geno's relocation kit install...
- Stack with a Superchip
- fass 95 / 150 how much hp?
- The FS 2500 Bypass oil filters
- How do bypass oil filters help our engines
- Blowing fuel back into the tank, Bad idea
- Smarty?
- Head Gasket Leak???
- Popping and Balancing Injectors
- Black smoke
- oil sender wiring
- 24v with a p-pump
- Fan Override Switch?
- power by poole @ fluid dampner
- CJ4 oil in 2000 24 valve (2nd gen)
- 99 ram 2500, lockup problems
- bad ait ?
- P237 = MAP Sensor voltage low, now what?
- Blew up my motor with 85k