- Bad lift pump out of the box?
- Are all VP44 the same ?
- Lift pump in single digit temperatures?
- transmission rear seal
- My first dead vp44
- hey Dan Pike
- trans doesn't seem right
- Fass in and Great Vendor/Amazing Service alert
- where is air in fuel press gage coming from?
- High RPM
- Cps
- Edge EZ vs. Van AAkyn
- Who has the EDGE COMP Shudder?
- Needle position on Temp Gauge when Warm?
- Please help with my fp numbers
- 13psi lift pressure(idle)......p216 code
- cold weather info?
- Thermostate Difference ???
- Need some help here guys
- funky OD shift in Cold Weather
- Shift on the Fly?
- Can Somebody Explain Drive Pressures & Measurement?
- 1998.5 Comp Boc Data Link ???
- Block Heater
- 6-speed possible seal going south
- Oil sender on the 01 HO
- vp44 on various engines....
- Help!!
- dyno tips needed!
- D80/tire/Speedometer Question
- 24 valve surging problum
- Truck barely started, very cold temps
- Boost good enough?
- Water/Meth for towing, lower EGTs?
- Drag-comp or FMS? ? ? ?
- HRVP44 question
- Pressure operated exhaust brake
- Fuel tank heaters. Anybody has one ?
- Cold Weather Idling?
- IS Blue chip pump cover TAP worth it?
- 4.10 swap for 3.54 and speedo change
- Does EZ Edge make a noticable difference?
- Factory High Idle is puzzling, but works now.
- Bully Dog Vs. Edge Ez
- anyone got a RASP & factory relocated lp?
- How does the FASS stand up to the elements
- Bumping the lift pump.....won't
- Tryng to drop weight
- lift pump
- Too Much Power?
- boost cooler/ snow performance
- second dead lift pump!
- Snow Water/meth Gains????
- 01 Dually w/ 4 Wheel Disc
- ATS Intake Manifold
- Gel Point Of Diesel?
- Turbo Advice
- Radiator petcock leaking
- ECM - VP-44 Cost?
- where to buy the water/methanol mixture?
- Engine Temp Quest on my 2002
- FASS turning off & on
- What the heck is the problem now........
- FASS 150 gph pump psi.
- Determine if VP-44 is a rebuild?
- NP241 HD - How to remove ext. house snap ring?
- found my low power problem -0216
- Check engine light and can smell raw fuel?
- Sourcing .355 rear end gear
- Block Heater Cord
- How to get stock HX35 to spool up more quickly?
- Instaling fuel pressure gauge
- how long does a hx35 live
- stacking anything with comp box
- codes
- Truck Died
- Synthetic Fluids?
- More power for my '99
- Buying parts
- Thermostat/Heat issue!
- FASS Electrical Question
- Check gauges/ No alternator gauge
- New 100hp injectors; truck stalls shifting into gear
- What size threads on the fuel return line to the tank at the engine T?
- Vulcan customer service AAA+++++
- What is Torque Management?
- Aurora 2000 Turbo?
- Importance of good fuel filtering
- where can I get a high Idle module/box?
- Gear Swap VS More Power? Advice?
- Tamper proof TORX bit source?
- Getting into the 12's
- I have new info on 24V LP issues...
- Have a problem with a friends truck!
- The Imfamous Exhaust Manifold Bolt
- ever heard of it --SWEPCO
- Slipping in Overdrive
- get rid of torque management
- vp and lift pump from 03
- Cummins Tourqe Management?
- Mallory 140 and regulator installed...
- 275 HP VP44 on my 01
- Curious About a Hot Rod VP
- How well does the TAG work?
- Trans temp
- 53 Block!!!!!!
- NV4500 synchro R&R???
- need injector opinions
- Ever have this happen?
- Weldon Pumps
- ARP Stud questions??? Retorque?
- DD super mental injectors??
- Rasp leaking at the pump. HELP
- anybody near louisville, KY?? and? about water/meth
- Remanufactured VP
- EGT's an ambient temps
- Heat shield on BHAF
- SuperChip and EGT's
- Truck bucked hard from a stop light
- need new lift pump
- Anyone have the pdf for changing injectors?
- Has anyone tried this??
- Comp with the Data Port Unplugged?
- Nv4500 Hd
- warranty work w/aftermarket parts
- Donaldson Oil Filters
- Power Steering Fluid
- Hard to Start
- Experience with ATS TC and exhaust brake
- Extended Idle Time.
- Special Tools Needed for Swapping Cams & Valve Springs
- Door Seal Problem
- Special Tools Needed for Swapping Cams & Valve Springs
- Truck dies if you cut out of the throttle to fast.
- Getting Cummins Tools & What to Ask For
- 12mm- 8AN line fitting?????
- Have no 1st gear and overdrive on 47RE
- Weird vibration in 4th gear on '99
- will the truck have enough oil?
- how much power do yall think?
- 2001 smokes heavy on start up
- 99 wont shift out of first gear
- Where is the APPS????
- Blow off valves?
- Ideas on Dampers
- codes with Hypertech
- Hot fuel killing lift pumps?
- Drive pressure Gauge?
- Thinking about Snow Performance Kit, opinions?
- Oil change
- Need help identifying this sound
- cold weather stumbling
- Starter issue
- ROKK Tech Cam Sensor on 2nd Gens??
- Troubleshooting soft brakes
- 5 inch downpipe available?
- Is my engine dying?
- fast idle after cruise control...
- no fuel
- Eating Steering Boxes. . .
- 2000 2500 auto will not shift above second gear - Corpus Christi, TX
- turbo over blower system??
- Working under the steering wheel and....
- what chips?
- Whats so wrong with the 24 valves??
- Brown Smoke?!
- What's your horsepower/torque estimate with this setup
- Tach Signal Please???!!!
- Engine bogs down? MAP sensor going out?
- For Those Who Haven't,reset Your Apps.....
- Have a fuel pressure problem question...
- Flywheel Thickness???
- Spring in bell House
- Cold Starts then dies whats up?
- I Can Smell Fuel
- Boost problem
- cyclic surging at cold temps...
- How best to sound insulate hood/firewall?
- vp44 replacement
- Here is a new problem
- Truck died
- Auto Trans OD inverter
- Air and fuel cut off switch
- howm many miles tapped
- Anyone hear of a S.P.E.E.D box programmer
- oil drain plug
- Injector Nozzles
- Manifold blues
- burning used motor oil
- A "Hopping" feeling...
- F-1 Mach 4's
- Fog Light Bulb
- VP44 question
- correction factor? what's the difference between....
- Cooling the fuel to the VP...10k miles of observations
- errrr... some help please~! Voltage (I think) problem.
- Carter 4601 set up help
- Carter pusher saves my butt - AGAIN!
- code 1693
- Crank sensor code
- More injector and less box - question related to EGT...
- Fuel pressure problem!
- Looking for HX35-12W
- Converting to 241 HD?????
- 24v why less idle torque???
- big fuel lines
- Interesting LP failure mode
- I found a great dealer today
- Surging & p0237
- Tranny Issues
- Pusher Pump?
- CAT in a 1989 Dodge
- Cpff???
- tps
- Turbo Help ????
- Where to get 100 & 300 psi guages to check trans press.
- Cold weather starting and new injectors
- Poll: What Kind Of Lift Pump Do You Run
- Input Shaft on the Auto Trans....Whose broke em & how?
- The Most HP from a box?
- What regulates fuel pressure?
- What EXACTELY is the injector return line?, et al
- PDR HX40 and ATS Manifold are installed!!!
- who does head machining and o-ringing in Connecticut
- Disable wastgate on 35hx
- Dual By-Pass Oil Filter Kits
- Schedule A or B?
- Boost Elbow
- Truck will not start
- How well does Van Aken work with Drag comp?
- Headgasket issues
- Why-why-why?????
- What should I do to store my truck
- Gorenend Bros and DTT torque converter question
- Has anyone fashioned an exhaust like this?
- Power steering pump screen...
- Help!!!! Will not start...
- The notorious 1693 code buddied with what?
- torque converter
- Foot in the Door
- Dyno #'s Banks
- Adapter Wiring Harness
- Alternator Question
- has anyone ever replace tone ring for ckp sensor
- Oversize Banjo fittings
- Transmission fluid?
- replacing vp44
- dyno today
- Funny Fuel Pressure Problem!
- Where to send injectors for rebuid?