- Chance to upgrade engine
- I might buy a new truck.
- Injector Limit
- Clutch pedal "pop"
- If YOUR thinking about -AN style fuel fittings.......
- power steering pump/vacuum pump
- Vp44 Question?
- What rear end?
- bgoodale
- Stacking A New Style Van Aaken with Superchips 3705?
- What rear End Ratio ?
- Radiator fan clutch
- lift pump pressure question
- Infamous Dead Pedal
- Lost all power! Help!
- Fuel Pressure help...
- First time installing new turbo...help
- new owner help with guage hook up
- pops out of gear with jake on
- No pulling power!
- SNOW's water/methanol kit
- Profile Pic
- Gear swap in So. Cal>?
- Whats the dry weight of a 24 valve head
- 98.5 24 valve Fuel Heater
- Cummins PowerSpec Software
- Worst case scenerio for APPS?
- Dual Disk Clutch Slave Swap
- Is dealer lying to me?? Help please.
- Short Shifter question
- MAP sensor
- Fass Question ?
- VP44 from cumminsstuff.com
- HTB2 or HTBG
- Inner Timing cover Gasket
- Blew The Head Gasket Need Opnions
- High EGTs
- 2nd Gen 24V Auto Turbo Change From HY35 To HX35
- Another cracked "53" block
- Allison Transmission
- What happens if you remove the blow by bottle
- guage readings
- Map sensor info
- APPS part #?
- New Mopar oil filter number - 05083285AA?
- Hello everyone!!
- New Injectors, what kind of mods to support them?
- Strange Starting Problem
- MPG Problem
- A little help on what is needed, my manual is at home.
- fuel pressure gauge problem
- fuel pressure gauge problem
- Hot Rod VP-44 failures???
- I plugged the turbo at elbow
- HO or no?
- Turbo upgrade...what's best
- Truck started, put it in gear, died and now won't start
- fuel system problems
- Billet fuel filter cap
- Idle RPM Question
- Westach fuel pressure gauge
- Smoke out of the vent tube, low oil pressure. What the problem?
- Need a New VP44, Which One Should I Use?
- scanner said injector pump problem, what next.
- 4" exhaust
- Radiator Repair?
- slight miss
- clutch change
- Need help with EZ EDGE
- So is it True?
- Mach 1.6 or mach 2's?
- Diesel clatter is missing!!
- b1 or b1-2? ? ?
- Starting in 3rd???
- P0219, Is this the end of my VP44?
- Why is my acceleration so poor?
- What Air Filter
- Can someone tell me why my truck gets 12mpg?
- Loosing Water
- BHAF installed.....
- Got (too much) smoke!
- Best place to buy a Lift Pump online
- Flex Plate...
- Tranny Part Numbers
- Interested in Trans Swap?
- Turbo Installer
- What is the best power mod... I can make
- Is Dodge going to offer the lift pump in the tank kit for 2nd gen trucks?
- T-Case & OD Unit Carnage - seen this before?
- 2000 Ram / Comp box surg problem
- Billet Fuel Filter Cap...
- Bosch 300HP injectors
- NV5600 oil change procedure
- No Speed till I hit 50.
- Southern Cal Shop recomendations?
- Turbo whine
- Truck Dead
- OBD-2 suggestions...
- Manual Trans Temp?
- internal injector failure
- BD Twins, No better than single. Why?
- Truck's Puking Tar & Locking Up
- Moving LP down to frame - longevity??
- why is my hp so low??????????
- Royal Purple ATF
- KDP Revisit 2nd Gen
- idle fluctuations
- Dtt ##
- Exhaust too loud, failed MA inspection
- Rust
- Diesel brain teaser
- BHAF & HP Lost?!
- engine power lost while towing
- F.A.S.S which is which
- Fuel filter ?
- Time for a trans?
- Dodge Ram Cummins Diesel Vacuum Pump Repair Kit
- Clutch hopping while towing-lower gears???
- Air box bolt size
- 99 24 valve
- Over Boost / Boost elbow question
- what causes a dead pedal?
- VP44 Crapping out?
- Performance box question
- Secondary lift pump specs
- lift pump harness?
- new 24 new questions
- DD comp box and service question.
- broken quick disconnect on fuel sending unit
- 1689 code even after new I.P. install.....
- Superchips or Edge ez
- Low power and **** poor mileage
- performance injectors and clutch 01 2500 6spd
- transfer case vibration
- 6" stacks...
- How are these fuel pressures?
- VP Failure at 198,000
- 4" exhaust vs stock
- Stock boost over 20 psi?
- Check Engine Light Driving Me Nuts!
- Transfer Case Tools
- I have the dreaded 0216 code
- Thanks to JR2 and BRobertson!
- CAUTION: Check Your Motor Mount Bolts
- help me with my edge drag box
- Mach 1.5's and EGT's
- Fluids
- fuel pressure ?
- Possible bearing noise
- P0237 Code
- Newbie with lots of questions
- Bucking stopped after APPS reset
- oil in turbo...
- Adjustable boost elbows
- What range fuel press. gauge??
- help truck dies then goes
- F.A.S.S Question
- where to mount relay and fuse on f A S S
- driving downhill with auto trans in low
- Have your rear springs failed?
- inch torque wrench
- 24v timing
- TST PowerMax question
- F-650/cummins motor
- STOLEN WHITE 97 4" LIFT TWIN TURBO'S SF BAY AREA
- Fan alternatives
- Starting is getting hard?
- I need some help with replacing the seal on the output shaft of my transfer case.
- Hybrid for me??
- won't start when it's hot
- Strange Starting Condition
- Need a new clutch.
- Exhaust Brake on Automatic
- White Smoke...
- VP question, correct me if I'm wrong
- Advice about towing power... or lack therof.
- Need second opinion
- Fass Question
- Group Purchase for AirDog ?
- APPS need resetting?
- injectors install manuals
- Cooling the return fuel from the VP-44?
- High fuel temperature?
- PCM causing fuel gauge failure?
- Fuel Pressure-Towing
- high pitched warbling noise above 9lb boost
- Lift Pump Part Number
- Pusher pump is noisy !!!!!!
- 5-speed to a 6-speed
- How much can I gain from getting more boost ?
- Can I modify anything with an ODBII scan tool ?
- Swapping out vp44
- Codes 0522 and 0523
- High pitch "whirrr" at 8lbs of boost:
- Engine oil temp, what's safe.
- Transfer Case Fluid Change, 2nd Gen
- Clutch replacement labor cost?
- Holley blue
- Truck dies
- RASP Install
- A/C Drain tubing
- turnbuckle ?
- HELP--tranny questions
- Vp-44 oscillascope readings can someone read these?
- Any Ideas?????
- Need good warranty shop in No. Calif. - code 0216
- Bio-Diesel and a sick VP44
- Where is a good mechanic south of Minneapolis, MN
- How come I cannot keep low rpms with an auto ?
- Stock vs. Catcher?
- Engine accessory failures
- Stack BD Plug N Play with Edge Comp?
- Flood Damaged 24 Valve
- Water/Meth. Is it worth it?
- Don't Know Where to put this Thread
- No power to F.A.S.S or stock LP
- valve cover coating
- Clutch engaging at top of stroke
- Lacking Power
- New lift pump need to be bled
- Beware when buying used parts on Internet Forums
- Speedometer input
- Ceramic ball bearing Turbo ???
- Can't hear lift pump-and 1693 code??
- Lightning Iinjectors from Scheid Diesel.
- How long does an Injection Pump last at 0 psi?
- slips at lockup
- MAP Sensor - Cummins part# ??
- Can in tank pump retrofit to a 2001?
- Cruise Control not working.....
- Front Seal Part #
- Whats the thread on the map sensor?
- Diesel compatible thread sealer?
- Flowmaster diesel can
- New Con OFE is in and seems to be working well.
- 24 valve cam
- New member with a fuel problem
- Swapping cams for lift 12V lift pump
- Does any one know of people who haven't had problems?
- Transfer Case Conversion Options
- lift pump problem. electrical?
- Steering box
- Need part # for silencer snap ring...
- blow by breather hose?
- COMP OR CatCHer
- Silencer Ring Removal
- Dana 70/80 Hybrid Axle?
- Need more power
- Bearing Noise
- 12cm vrs 14cm TURBO exhaust housing