- How much boost is too much?
- Preventative maintenance
- Captain Forgetful .... carter pusher #
- Looking for a re-furbished Edge
- Fuel Pressure numbers
- another fuel pump gone?
- Transfer case seal
- Engine Block number "56"
- Manual to auto conversion
- Throttle Posistion Sensor!
- Cummins Manual
- Valve Cover
- bombing detection 2001-2002 eth engine
- Severe service definition, new addition?
- Comp/HO dyno #'s...
- Looking For 03 Turbo Specs
- LF3894 Micron rating?
- Lift pump woes !
- Edge Comp Installed, Yee Ha
- 98.5 24v VERY ROUGH Idle (not same old thing?)
- Need help big time.
- Thread sealing on FP Guage.
- 1500 rpm at 71 mph!
- Prospecting an eth dee? ? ?
- injector box combo
- Using oil
- Copper
- Mad Ecm?
- size matters??
- Fleetguard Oil filter - 12v vs. 24v
- Installing a liftpump switch.
- Limited Slip Diff's
- What RPM shift range?
- anybody got a VDO Vision fuel gauge?
- 6 speed question???
- What, Piers not allowed at BD? You're kidding, right?
- Grid heater fix
- torque settings
- Automatic upgrade did I pick ATS or DTT?
- Factory high idle with Edge Comp?
- More Newbie ???'s
- Needing clutch cores
- trans temp
- Fuel pressure on the rise?
- Venting to D/C on Engine Choices! :Exposure thread:
- Really fast Cummins
- Is my lift pump going bad?
- Power-puck, Edge, or injectors for towing?
- got a little $ which gauges to buy and from whom?
- Okay need torque converter
- p 1693 code? Boost elbow.
- 5 speed and rear end fluid?
- Missing at rpm - new owner
- limited slip??
- Dana 80 & limited slip
- Front Axle Nut
- egt gauge
- DTT Installer
- Dana Model 70 Fill Plug Change
- Banjo fitting size
- Lets beat the 18-31-01 TSB horse somemore
- Front end worn out at 91K
- Injector Tube Replacement
- one righteous place
- Fresh cool air for my Cummins
- 47RE Auto Tranny Rear/Front band adjust
- How many 24 valvers read the 12 valve forum?
- auto trans. question
- Dana 80 Temp
- A lot of info stored in our trucks
- fuel pressure question
- Wheels
- Drain plug size
- RP Synthetic Power Steering Fluid
- Interesting LP question
- Should I trust my truck to a drive up oil station?...
- Manuals
- pusher pump ?
- Front shock replacement
- TST injectors??
- newbie questions
- thermostat question
- An electrical guru I aint.
- 24v gone at 14,000 miles
- Steering
- Another Lift Pump Nightmare
- general VP questions
- Leaking Banjo's
- Hybred Turbo's
- stupid question about AN lines/fittings
- Lift Pump ?
- stock clutch slipping
- turnbuckle/spring = no change at all
- Whining about..oops I mean in 5th
- Brake lines to rear end
- Oil pan removal- in frame?
- What's the biggest injector one should use in the winter?
- Fuel Millege
- Pyro Inaccurate?
- Pac brake use
- high idler
- Antifreeze
- What's that smell?
- rotor upgrade
- Moving on up..........to the east side
- DO you put a medium liquid thread locker on banjo bolts?
- power steering problem
- Oil pan gasket changing question.
- Dino Oil
- Rear Disk Brake Conversion...
- sensor problems/miss at idle
- wheel torque
- broken valve spring
- Fan Belt
- 00 wastegate
- Lukes link or what?
- truck just died, need help fast
- Do I need BHAF on stock truck with EZ ?
- Do I need injector upgrade?
- changed fuel filter first time on new 002 24v
- fuel line size for fuel pressure sender
- Is this guy blowing smoke (not out his exhuast)?
- H/o And Edge Comp
- crazy FP readings
- T/C and V/B upgrade with stock truck. who has done it?
- TST evidence
- Pre-Turbo or Post-Turbo for Pyro
- stearing box
- latest lift pump info from "Star"
- How hot is the turbo oil back to the filter?
- 1/8 or 1/4 for pyro probe?
- turbo sick...need advice
- Check engine light
- Starting after lift pump replacement..
- follow up on 180 t-stat
- Does anyone have a picture of a lift pump ?
- Brake line rubbing on tire???
- Fuel Pressure Gauge Install, Bleed Air Needed?
- Billet imput shafts?
- possible Bomb evidence?
- Towing with Edge EZ
- 4WD top speed?
- throttle position sensor.
- Transmission temp sensor
- replacement for auto tranny
- John Deere Lift Pump
- PowerTrax No-Slip
- Questions on 5th Gear Repair
- ECM uprate at cummins
- What numbers should I see for boost?
- My first lift pump
- Killer Dowel Pin
- fine tuning ear to engine
- Thermostat part #
- Are pusher pumps noisy?
- Relocated lift pump too noisy !!!
- injector tube change-over
- Vacuum Pump leaking oil= HELP!!
- Stripped Turbo Housing at Boost Elbow (Pics)
- Engine out @ 70k- what else?
- Angle for Oil changes
- Replacing a cracked block under warranty?
- Fuel pressure gauge.
- who's got best guages and cost?
- RP Synchromax in the NV-241
- squeaky clutch pedal
- Tranny temp sensor adapter
- whats next ????
- John Deere Hy-Gard for NV5600????
- Shoshoni, Wy TDR member
- 245R16 or 265R16
- low power
- Hard Starting
- LP pressures at start up.
- Engine Dropping to Idle, Check Engine Light On
- Limited Slip Additive
- another auto tranny question
- Lost my fuel mileage!!!!
- Hope the new Cummins doesn't start having injector problems like this???
- strange noise between shifts
- Lost tach, Thanks to all....
- Bombing a 24V 101
- Twins Installed!!! Yehaw!!
- bad shake
- Blew up the front axle!
- Ez & DdII ?
- Lift Pump Decision
- IAT cleaning
- Major Problem...Need Some Help
- how do I make my truck do this
- best place to buy a lift pump?
- wanna buy a turbo!
- EGT's with new turbo/4"exhaust
- Lift Pump Going Out/New Specs?
- Edge Comp and EZ Power (sub)Levels Explained…
- What seals the Camshaft Position Sensor?
- Injector fittings coming loose
- Pacbrake Install / TROUBLE
- Trying to squeeze every bit of horsepower out of this thing
- Manifold torque # & sequence
- installed edge ez fuel leaks
- Popping noise while turning
- oil on outside of turbo
- K & N Air Filter Grease
- Who has had a VP-44 failure?
- Great Dealerships
- Gimme a VP-44...to go!
- 4x4 Noise & Pull
- Dupli-Color MetalCast
- trans temp hookup
- turbo problems?
- First oil & filter change
- Got to get more GO!!!!!
- Question about VP44 overflow valve????
- -8 AN and highflow fuel filter install
- Partial Drain w/ELC?
- Synthetic Powering Steering Fluid?
- transmission problems
- exhaust for a cummins
- Interesting news about the LP
- turbo and head gasket
- VW TDI/Cummins
- valve cover torque
- Turnbckle method?
- Oil pressure????
- Winterizing
- Edge EZ
- Dana 80 lube fill
- Oil Pressure Sending Unit Died(Damn Near Took Me With It)
- boost and pyro #'s
- 6 speed fluid change
- Add me to the DEAD VP44 list
- Tranny temp..........again
- injector help...quick!
- Fuel Pump Stupid Question
- Friction Modifyier w/Mobile 1 75-90
- auto tranny finally gave out
- Should I move my lift pump?
- EZ on 99 without elbow
- Waste gate ?
- Why does the Edge Comp module only let the PCM see 3\4 throttle at full throttle
- edge pulse
- pre-strainer/fuel heater, what years?
- stock HX35 and boost levels
- Synthetic True Blue Too Soon?
- Edge EZ and J-hook
- Differential Fluid Level
- Noise(s) W/ DTT Install
- got 275's ready
- Fuel Return Check Valve