- Anyone dyno an HO 6-speed with ONLY a Comp added?
- Turbo bark on PDR HX40-16 question
- Who said changing Banjo Bolts was a 15 minute job?
- air filter
- VP44 failure rate poll
- Torx plus tamperproof #25
- What is the web address for Enterprise.
- Front axle reverse rotation or not?
- Can my clutch survive
- 6-speed and trans case fluids- synthetics?
- Short kills my MAP sensor
- Stock ETH smoke visible at night
- 2002 6 speed or auto???????
- DTT Update Kit
- 275's and power
- VA for a y2k ISB....
- Bizarre shifting thing going on???
- Bolt Sealer NV 4500
- Guages - Your Info
- Comp quit & Engine light is on
- need smoke...need suggestions
- Boost Q
- Looking for some 3" 12 guage to replace muffler?
- Buyer Beware
- Tsb 09-2002-09
- Not impressed with PE comp
- Injectors and box, effects on pump life?
- RPM Hiccup (?) What is it?
- Lift pump is on it's way out.
- Engine Stumble
- How good is the 2001 six speed
- OFE-- enough clutch?
- Running empty with EZ and 275's.
- Cummins ECM
- Accelerator Pedal Position Sensor (TPS) problem?
- Guages and Readings
- New Lift Pump Pressure's
- What mods are needed to run a set of 38's or 40's
- stacks installed, what about aux fuel now
- Nv5600
- New Turbo!!
- 99 CTD for sale!
- Just got a quote for an '02 what are these emissions packages.
- Story of 1st fuel filter change, hard starting
- EGT thermocouple test procedure?
- cruise control
- Excessive Exhaust soot
- fuel pressure gauge & banjo bolts
- TC unlock mystery switch
- Had a question about the HY Turbo
- ATS T/C install and V/B how hard to adjust
- Adding and AFE and dumping the muffler.
- Installed a pyrometer friday and have ????'s
- vender to exch 5 for 6 sp???
- new clutch and renew 5 speed or put in 6sp
- NV5600 Lube; RP Synchromax?
- Truck shudders when braking (sometimes)
- Fuel filter canister?
- What size socket for the IAT in a 2001 ETH?
- My Turbo Experiment
- Pusher Pump & PSI Solution?
- Trans temp sensor install - how much fluid loss??
- Bhaf
- injectors or box
- FYI...shifting difficulties
- IAT sensor
- fulel injection pump out
- Help with DC Manual
- Coolant Temp
- PDF instructions to install injectors
- Amsoil Oil and Filters 24 Valve??
- Changing Fuel Filter in 2001
- Zerks and Lubing
- Re cheap high idle switch
- Idle Skip - After the Engine is Warm
- Which Turbo, Propane?
- ABS and Brake light stay on.
- Problem with VP-44 labels...
- Turbo Cleaning
- 16cm housing on 24v
- Power Max 3
- front three or rear 3 cylinders/pyro mount
- On a 2001 Auto by BD Power, How do you change shifting points?
- idle change
- Convenced the ******* finally
- How to spend $2000?
- FYI - Cummins Part # for MAP and thermostat for 1999 auto
- aftermarket power boxes WILL void warranties
- Edge comp
- FYI - Cummins part # for 2001 ETH MAP Sensor
- Anyone running ATS injectors out there?
- 2001 Auto Trans Troubles
- Tsb 09-002-02
- want to know your stock boost numbers!!
- Before & After Engine Pictures
- Fuel Guage inaccuracy
- Other Drivetrain weak links
- VP-44 noise?
- Super Plug
- Auto trans fluid
- 5 spd Trans fluid change
- Banjo Bolt ???
- truck pull's to right
- spa guage installation
- Boost #'s with Edge EZ ONLY!
- Doc
- Boxes
- Need advice, Pulse or Comp box
- Dana 70 to 80 conversion
- Goodyear RTS tires
- Lift pump noise
- Tsb 02-003-02
- automatic tranny
- Tranny temp gauge install?
- What oil from factory?
- edge comp
- Banks Power Sys and slipping Trany (long)
- AFE and V/A with stock Automatic?
- are our engines turbonormalized ?
- Do it yourself adjustable boost elbow
- Dana 80 fluid
- clips on injector lines?
- 2002, which engine/trans, gear ratio???
- Runs fine, Zero fuel pressure????
- Check Engine Light
- serpentine belt
- P4601hp Dead!!
- Rear Differential help needed
- Lowering Idle in PCM
- check engine light+tach flutter=bad crank sensor
- Repair Shop??
- what type/size wrench for '01.5 front brake calipers?
- <300hp? 4" exhaust is a waste of money!
- will this fuel filter work
- OBD reader / eraser
- Injector Install
- Just drove a 2003 HO 6 speed.
- oil drain plug problems
- Scotty Air System or AFE or other?
- New lift pump, what connector
- 100000 miles now what?
- I need a lift pump wiring plug adapter.
- Need tranny troubleshooters...
- hard starting in the morning, small leak at fuel guage?
- Cranking longer to start
- A few oil questions
- TST Comp Box
- How Much CFM Does the Cummins Need? (Keepin' it cool)
- which boxes are timeing boxs only
- Ticking noise?
- gear change cost and difficulty
- Diesel Power Products Exhaust
- turbos.........think outside the housing
- Time to change the big ol'drive belt?
- 6 speed clutch and EZ
- Battery/BHAF location/lower EGT?
- Dakota Digital F.P. Gauge
- Tranny cooler fans
- Front wheel bearing replaced
- Need advice on EGT
- Why oil pressure change?
- 24v......want better milage. Here is the fix
- transmission pressure
- Looking for Factory Service Manuals
- Valve body and drill????????
- Still having clutch (slave cylinder) problems, please help.
- What interface to buy?????????/
- Cold start up question
- BOMB by cummins
- now I'm really excited
- Differential swap
- fuel pressure at VP44
- would this be an answer to lift pump problems?
- intermitant loss of power
- valve adjustment
- trans gauge
- TSB 18-024-00 on a 2001
- need drill size to tap ex manafold
- Pressurizing intake/intercooler to 30psi?
- Engine Malfunction light
- After you've replaced the PUMP,theFILTER
- ATTN: Gary - KJ6Q (RE: EGT's and defective thermocouple)
- error codes...truck seems fine
- What size socket?
- 2-3 shift question
- Cruse Control
- does your exauhst brake work in O/D
- Uncontrolled Engine Acceleration
- Dodge Turbo Diesel
- Oil drain plug failure
- Transmission Fluid
- premature trackbar/draglink failure
- Need 4" tailpipe, where can I get it
- Clutch quit working completely today.
- Lift pumps...lets think outside the box
- Okay! Removing resonator and muffler!
- block drains?
- Fuel Pressure
- Engine Miss/Studder
- Larger Tires.
- Still need help w/ EGT's
- P/S steel pully (shiev)
- breather bottle TSB
- powder coating
- Need fuel Preheater
- Need Hot Diesel
- I'm excited
- EZ comp and fuel mileage
- I want steel wheels
- decent dealer...
- Fuel/water separator
- Anybody use Oilguard bypass filters
- Dual Bypass with two full flow filters?
- P0460 ????
- Van Aaken D-500 or Edge EZ?
- Dealer test's fuel pressure different
- Fuel Pressure
- photo of digital fuel gauge installed
- Fuel filter
- In need of a computer interface
- Uh Oh.... TPS Going ?
- Recalls
- Help!!....Is my Auto toasting itself??
- Removal Dash Trim
- Any propane injected HO's out there?
- Good (and bad) dealers in Arlington, TX?
- Drilling Banjo Bolts
- transfer pump recall maybe
- Oil report #'s
- What fuel gauge to install and how?
- Wastegate Turnbuckle
- A good reason NOT to buy the Jacobs exhaust brake
- membership pays off
- Installed a 4' exaust today...Whew
- Combining Boxes
- Edge Comp & AFE Mega-Cannon Installed!
- Rebuild cost
- 50K Gearbox Lube Report
- ******* Dealer ?
- Comp on ETH
- Cracked Manifold & My ******* (HELP!)
- The 53 block
- Vp-44
- Auto Trans
- 24V Oil Pressure Sending Unit
- Analysis on Rotella at 8200 miles
- Can I tee off of the boost elbow port and run a boost gauge?
- Will my VA box work in all 24 valvers?
- vents blow less when A/C is on max?
- fuel economy/gear ratio