04-15-2005, 04:39 AM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
Join Date: Nov 2001
Location: Columbus, Indiana
Posts: 5,415
|
|
Drive shaft angles...w/carrier
I recently had problems with 1st and 2nd gear take off vibration.
I narrowed it down the the driveshaft angle aft of the carrier unit (too much downward angle).
Well I installed about .5" worth of stock above the carrier unit and this has almost aligned both shafts together.
There is still about a couple degrees of downward angle after the carrier housing.
All take off vibration is gone.
My question: Can the shafts be aligned too perfectly? or should I have a certain amount of downward angle to allow for upward articulation of the rear axle?? (ie sledpulling, heavy loads etc.?)
?????
Thanks for the help!
__________________
3rdGen SLEDPULLER
Videos: 12345
|
|
|
|