10-01-2007, 03:49 AM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
|
|
Rebuilding an engine
I didn't get any responses over on the 3rd gen forum, so I'm reposting here.
I spun a bearing or threw a rod or something in my 2006 engine, and due to rather extensive mods on my part, it's not under warranty. Anyway, I now have the opportunity to rebuild the engine from the ground up. What I need is some suggestions on mods to consider when I'm putting it back together. This would be stuff like flycutting the pistons, special coatings, blueprinting, boring, stroking, etc. It's for a daily driver that will end up getting every power mod I can think of thrown at it eventually. It needs to be reliable and driveable and fast. Currently I am planning on heaving the head ported with the Extrude Hone Powerflow AFM process.
Any ideas from all you engine builders out there? What should I be thinking about?
__________________
2006 2500 2WD Laramie Megacab CTD - HT 62/13 SS turbo,Scheid cam&port&springs&studs,ZZ manifold,Hot Juice&EZ,aFe Stage 1,DPP Cool Hose&TAG&EAG,Spearco IC,ATS ex. man.,Flux 1's,DIY CP3 mods,T&C Rail,GDP Fuel+2µ filter+intake,Rokktech Muffler,HTS billet trans,CalTracs,OBA,CoolingMist--- My Gallery
|
|
|
|