Setting up a hydraulic slave cylinder

If you don't wish to see these ads, that is one of the many benefits of TDR membership. To receive a free copy of the TDR magazine and find out more information about membership benefits click HERE.

		TDR Roundtable > General Turbo Diesel Topics > Cummins/Diesel Conversions
Setting up a hydraulic slave cylinder

Thread Tools

Display Modes

Setting up a hydraulic slave cylinder

03-24-2005, 05:41 PM

#1 (permalink)

driverswanted

Non Member

Offline
Join Date: Jan 2003 Location: Middlefield, Ohio Posts: 265 Old Reader's Rigs Gallery

Setting up a hydraulic slave cylinder

I have a GM clutch and fork ***'y and a Dodge hydraulic master/slave cylinder ***'y. What is the best way to set the slave cylinder and clutch fork so the release bearing does not spin w/o clutch depressed?

__________________
1985 Dodge Ram 4x4 Prospector shortbed with 4BT; 3" lift & Air bags, 3.55 gears; NV4500; 4" stainless exhaust, HY35W, Bosch 190's, 6BTA intake horn and heater grid, 6BTA air filter housing with K&N.

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

All times are GMT. The time now is 12:13 AM.

Mark Forums Read | View Forum Leaders