12-21-2002, 06:50 AM
|
#1 (permalink)
|
Offline
|
|
Join Date: Aug 2000
Posts: 424
|
|
Expoxy-Cold Weld Advice Needed
Have a tiny pin hole in the small expansion plug below and behind exhaust port number six. Access is very tight, R/R possible but tough.
Going to try to plug the hole before attempting the R/R, appreciate any advice.
Related topic in 24V forum.
http://www.turbodieselregister.com/f...143#post560143
Thanks,
Neal
__________________
2001.5 2500, QC, LB, 4x4, SLT+, ETH, 3.54 LSD, DiProcal EGT, Boost and Autometer Oil Temp gauges in an Autometer dash pod, SW Electric Fuel Pressure Gauge, Donaldson ECB10506 Air Filter, Carter HP4600 with Earls PreFilter, Dynomax 17223, BU lights that work, EZ, BD IIs, 350 hp 810 ft lbs
|
|
|
|