St. Louis Dyno Pull - Special EVENT!!!!

[OT-OF-HERE!!]

You won't want to miss this special Dyno Event featuring the VA-C5!!!

MCS Midwest Performance Diesel has partnered with Van Aaken for a very special Dyno Event. For this pPull you will need to remove all power adders from your truck (No boxes or Downloaders). MCS will install the C5 on your truck. You will get 3 runs on the dyno. The 1st run will be a baseline run with the C5 on the factory setting. The following two runs will have software upgrades done on site. You will get to see "how to" make these upgrades on a huge overhead,... you'll get to see each mouse click!!! And here is the biggy,.. Van Aaken is sending one of their Tech Engineers from the UK to MCS,.... on site to do the mods and tell you how to do it.

No where in the country has an event like this occured so don't miss out. You are not obligated to buy anything,.. however there will be units available on site for purchase at a promotional rate which will mean a savings of a couple hundred dollars!

Think about it,... you have a tremendous investment in your truck and all the mods you have made to this point. You can't afford to blunder through software tweaking,..... and you don't have to,.. Van Aaken's top dog will be there to demonstrate for you. Don't miss this event!!

Mark your calendar - Dec 1 & 2. As this will be a two day event, then refreshments will be available on site.

You must be prescheduled and prepayed for this event. Call 636-451-4144 and ask for Keith. He will give you specifics on pricing for the pulls with the C5. MCS features their Mustang Dyno for this event.


When: Dec 1 & 2
Where: MCS Midwest Performance Diesel (MCS is located on I-44 2 exits West of Six Flags at the Gray Summit Exit. Go to the South Outer Road and go 200 yds back East and turn R. at the 1st turn. MCS is on the Hill overlooking the Highway.)