02-22-2005, 04:01 AM
|
#1 (permalink)
|
Offline
|
|
|
|
Solidsteel track bar bracket install problem
I'm in the middle of installing the Solidsteel bracket on my '96 for the 3rd Gen track bar upgrade and the head of the bolt that goes through the middle of the bracket rubs hard on the steering shaft.
Any ideas???
I am using a washer on the upper side like the directions show, without it the head should clear OK but I don't like the idea of torquing 40 ft/lbs and having all that pressure concentrated on one small spot.
I may grind the head down but I'll have to grind at least half the head away to make sure it won't ride on the steering shaft.
I did a bunch of searching but didn't find any posts of anyone else having this problem.
Thanks, Vaughn
__________________
Gone: '98 CC 4x2 SB 12v auto, 213,300 mi.
Daily Driver '96 CC 4x4 LB, 5-spd 3.54 LSD, PDR 175 pump, Hybrid 35/40, DDP Stage IIs, SB 13" Clutch 465,787 mi.
Rob Hanson, thank you for the memories;
RIP Nowel "HVAC" Thomas
|
|
|
|