06-22-2008, 01:03 AM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
|
|
40 gallon toolbox/tank in 08 Dodge
I just installed a tank in our new 08 Dodge and I got no response from the pump when running the test procedure.
There are a couple things that could be causing the problem that I can think of.
1. I am not getting ignition hot power, I did not have a test light so I pulled power from the sunroof fuse. I am just not sure I am on the correct side of the fuse. ( I am going out to check this later) For now we unplugged it.
2. The gauge on the dash/factory tank has too little fuel in it. There is only about 1/8 of a tank right now.
3. I screwed something up.
Because the pump wouldn't come on I unplugged the power from the fuse panel. Now the guage on the dash is pegged at empty, is that because there is no power now? If that is the case I am assuming that the main tank is too low to run the pump and/or test procedure.
I will report back with what I find, I am posting this for the small chance someone can give me an answer in the next hour before I head back out to trouble shoot.
Thanks, Joe
__________________
2004.5 2500 Quad Cab SLT 4X4, Cummins 600, 6 spd, 3.73, Smarty, HTT 62/14, SB OFE, Pacbrake PRXB, Diprocol Optix EGT, Boost, Fuel Psi, D25's, Bilstein 5100's, 35" Toyo M/T's
My Amsoil Site
Smarty Revo on 9 TST on 2X1 522HP / 1,057TQ
2007 Springdale 267 TT 8,000lbs
|
|
|
|