03-24-2002, 02:48 PM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
|
|
How tight to get fitting for Briar's Gauge?
I put in both Schrader valve fitting for Briar's Fuel Pressure Test Gauge, but after looking at the fitting last night, they seem to be leaking some fuel.
When I installed them, I tightened them down quite a bit, but I they never stop tightening. I didn't want to strip them, but all I was using was a 3/8" drive. Did you guys torque them to a specific setting or did you use Teflon tape or something?
__________________
98 3500 24V, 5 spd, 4x4, Alcoas, 305 hp, 850 ft/lbs, lots of custom mods...
|
|
|
|