10-20-2006, 12:38 PM
|
#1 (permalink)
|
Offline
|
|
|
|
Need air compressor to power 5" remote mount pacbrake
Hi,
I have a new 5" pacbrake remote mount exhaust brake. It needs 60psi to close. So I need a on board aircompressor to power this somehow. I have a small air tank, and I do also have a complete 5.9 p pump and holset gear case aircompressor setup, That I could attempt to fit. It may be a tight fit, depending on what vacuum pump I run, or if I swap to hydroboost brakes. This would get rid of the vacuum pump. Any ideas? Either the cummins factory setup or a 12volt aircompressor that puts out a lot of air... ie if you use 60psi to activate the exhaust brake and you use it very often ie traffic , I imagine it will run low on air very fast..
Thanks,
Deo
__________________
2000 Excursion XLT 4x4, P Pump 12V Cummins, O ringed, lazer DV, 370's, G56 6 speed, Southbend FE clutch, guages, 4" Remote BD Ex. Brake, full vinyl floor.
http://picasaweb.google.com/therabbittree/Excursion02#
1992 Dodge W350 srw 4x4, Getrag, 3.07's, PODs, guages, 5"stack, 8' dumping flatbed,
Last edited by therabbittree; 10-20-2006 at 02:53 PM..
|
|
|
|