09-05-2007, 08:28 PM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
Join Date: Aug 2001
Location: Ephrata, Wa
Posts: 769
|
|
Sealing hot pipe to HX40
I finally have my 40/3B twins installed. When I close my exhaust brake and check for leaks I am getting a leak between the hot pipe and where it bolts onto the 40 with a copper gasket. Not a gushing leak but it's still there and I'm not sure how much effect it will have. I guess for those surfaces to seal air tight with the copper gasket they'll have to be flat within a few thou. which isn't the case.
Anyone ever used a thin coat of hi temp sealer on the gasket face to get a nice tight seal? Maybe some hi-temp RTV or ? I'm thinking about pulling the gasket, giving it a thin coat, put it together and snug the bolts, leave it over night and crank the bolts up the next day.
Mike
__________________
96 club cab 4x4, Quad 4x4 NV5600 conversion, SB FE clutch, Auto Meter Ultra Lite Boostx2 Pyro and Fuel Pressure, TST #10 plate, 3K GSK, 370s, O-ringed head, ARP 12mm studs, NW Customs HT3B/PDRHX40 twins, PDR Intercooler, Snow Performance H20/Meth inj., 4" BD Remote brake
|
|
|
|