03-04-2003, 07:52 PM
|
#1 (permalink)
|
Offline
|
|
|
|
ATS Manifold Heater Bracket...
Re: ATS Manifold Heater Bracket...
Jcbrown requested a picture of the heater bracket we made for the ATS manifold. Here is a small close-up. The bracket is made from some flat 1/8" stock. The original bracket on the heater tube was cut off about an inch from the tube to make a tab. The tab was then drilled for a bolt. The steel was then measured and bent to fit and a hole drilled in both ends. A little paint and voila. Hope it helps.
__________________
2001 3500 QC 6X4, Auto (DTT), 4.10 LS, 19.5 Alcoa Wheels, Michelin 285/R7019.5 XDE2+, PacBrake, etc...
Full Signature or Truck Pictures
|
|
|
|