07-05-2003, 06:28 PM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
|
|
ATS Manifold Assembly problems
OK- I've read through pages of suggestions and am stuck with putting the stock manifold back on at this point  !!
The da** thing will NOT go together! I have antisieze. I put one in the freezer, one in the oven. I even tried a microwave oven  . No seriously folks, it will not go. I even tried a rosebud tip with my Oxy/Acety torch. I didn't want to get it too hot for fear of damaging the coating.
Which leads me to this: Is or can the coating interfere with the assembly?? I was under the impression that the coatings weren't all that thick, but maybe this is a thicker than normal coating?
I am concerned about taking any to and sanding because I don't want to screw up the tolerances.
Any suggestions??
Kev
__________________
01' 3500 2wd QC HO/6sp * 275's & EZ * SBC Con OFE * Alcoas * Jacobs Brake * Lots more
So Cal Rattlin Rams WEBSITE
President & Founder- So Cal Rattlin' Rams - For info info@socalrattlinrams.com
|
|
|
|