11-03-2006, 05:07 AM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
|
|
Craftsman Torque Wrench Problem
My 1/2 Drive Torque wrench just started giving me some crap. I set it to max (150ft lbs) to torque the axle nuts on my jeep and had hell getting it there. I had to put a long extension on it and squeeze the holyfriggencrap out of the handle to get it tightend up that much. I had the same hell backing it off as well. Its fine once you get it below 75lbs or so but its almost a two man job anywhere over that. It seems to operate normally otherwise. I did forget to back it off awhile ago and it was set at 95lbs when I pulled it out of the box, it probably only was set like that for a few days.
Any Ideas? FYI this is an older one that has a metal handle not the newer plastic handle.
__________________
2000 3500 5-speed, stock(I know sad)
|
|
|
|