|
Pneumatic Punch & Flange tool
I recently bought a jeep to start as a project and the previous owners went a little over board on the bondo so I want to cut out the bad section and weld in a replacement panel. I was hoping that some one could recommend a good Hi quality Pneumatic Punch & Flange tool that is USA made. I was going to get one from snap-on but the one they sell only punches hear is a link
AT185, Punch Tool, Dual, Air, 3/16" and 5/16"
Any help on this would be greatly appreciated… What kind of Punch & Flange tool do the top end body shops use? I know it’s probable more than what I need but if I’m going to buy one I would like to have it last forever and work when I need it
Attached is a picture of what I’m fixing
Thanks
__________________
2004.5 2500 QC 4x4 6 speed all the guages 4" Exhaust, BD inline E-Brake, Smarty, warn 12000 winch home made bumpers front and rear
|